Emerson InSinkErator Instrucciones De Instalación página 4

Turn off water supply before starting.
Installation must comply with all state and local laws and regulations.
1
INSTALLING FILTRATION SYSTEM
INSTALLING FILTRATION SYSTEM
A
Personal Injury: Do not locate filter above an outlet or other
electrical device. Install head and bracket so that connections
require no stretching, kinking or pinching of tubing.
B
from water
supply line
Property Damage: Tube runs need to form to the cabinet's
contours to allow storage space with no sharp bends. Tubes
need clean, perpendicular, burr-free cuts to ensure a true fit.
C
Two water
dispenser lines
From filter
To remove tube(s) from quick-connector,
depress the release ring and
D
Discharge
tube
From water
supply line
It is normal for approximetly 2 oz. of water to
discharge when filter is removed.
4
One water
dispenser line
Plug
From filter
gently pull tube away.
■ ■
Mark hole locations for filter head
and bracket in a spot that allows for
filter replacement.
■ ■
Drill 1/8" starter holes and attach
bracket to wall with wood screws,
turning until snug.
■ ■
Remove red filter cap, insert filter
cartridge into filter head and twist
clockwise until "LOCK" arrow on the
filter aligns with arrow on bracket.
■ ■
Determine length of tubing required,
then cut to length making sure the
cut is perpendicular and burr-free.
■ ■
Insert a white 3/8" tube into inlet
to other
side of filter head until it stops.
plumbing
Press in again to ensure a secure fit.
fixture
■ ■
Insert the other white 3/8" tube
into outlet side of filter head
until it stops. Press in again to
ensure a secure fit.
■ ■
Insert the copper tube(s) from the
water dispenser into the 3/8" to 1/4"
quick-connect fitting.
■ ■
Connect the white 3/8" tube
from the right outlet on the filter
head into the quick-connect fitting
until it stops. Press in again to
ensure a secure fit.
■ ■
To redirect filter replacement water
discharge, place the supplied 6"
clear tube over vent hole on the
left side of filter head.
To faucet