Pur Line COOLY 9000 A Manual De Instrucciones página 30

EN
· Purge the refrigerant circuit with nitrogen for 5 min.
· Evacuate again.
· Fill with nitrogen up to atmospheric pressure.
· Put a label on the equipment that the refrigerant is removed.
DISPOSAL
· Ensure sufficient ventilation at the working place.
· Remove the refrigerant. If the recovery is not required by national regulations, drain the
refrigerant to the outside. Take care that the drained refrigerant will not cause any danger. In
doubt, one person should guard the outlet. Take special care that drained refrigerant will not
float back into the building.
· Evacuate the refrigerant circuit.
· Purge the refrigerant circuit with nitrogen for 5 min.
· Evacuate again.
· Cut out the compressor and drain the oil.
TRANSPORTATION, MARKING AND STORAGE FOR UNITS THAT EMPLOY FLAMMABLE
REFRIGERANTS
TRANSPORT OF EQUIPMENT CONTAINING FLAMMABLE REFRIGERANTS
· Attention is drawn to the fact that additional transportation regulations may exist with respect
to equipment containing flammable gas. The maximum number of pieces of equipment or the
configuration of the equipment, permitted to be transported together will be determined by
the applicable transport regulations.
MARKING OF EQUIPMENT USING SIGNS
· Signs for similar appliances used in a work area generally are addressed by local regulations
and give the minimum requirements for the provision of safety and/or health signs for a work
location.
· All required signs are to be maintained and employers should ensure that employees receive
suitable and sufficient instruction and training on the meaning of appropriate safety signs and
the actions that need to be taken in connection with these signs.
· The effectiveness of signs should not be diminished by too many signs being placed together.
· Any pictograms used should be as simple as possible and contain only essential details.
DISPOSAL OF EQUIPMENT USING FLAMMABLE REFRIGERANTS
· See national regulations.
STORAGE OF EQUIPMENT/APPLIANCES
· The storage of equipment should be in accordance with the manufacturer's instructions.
· Storage of packed (unsold) equipment.
· Storage package protection should be constructed such that mechanical damage to the
equipment inside the package will not cause a leak of the refrigerant charge.
· The maximum number of pieces of equipment permitted to be stored together will be
determined by local regulations.
28