Simeon 500IR Manual De Usuario página 5

Setup
Carefully unpack the soundfield system and separate its components.
Simeon 500IR Portable Speaker/Receiver
The 500IR has two IR receiver modules, an integrated speaker, and multiple
input and output connections. It is at the core of the entire sound system.
It is recommended that you charge the receiver fully before its initial use.
Identify the correct power adapter for the receiver.
dard power adapters to charge your equipment.
the battery [8]. Make sure the receiver is OFF while it is charging [7]. It takes
8 – 10 hours for the receiver to charge. An indicator light will glow red during
charging [6]. When it glows green, charging is complete.
Simeon IRS-20 Remote Infrared Sensors
The IRS-20 improves the range and reliability of your infrared field while being
versatile in its installation or positioning.
The IRS-20 can be placed on any surface or it can be wall or ceiling mounted.
Use screws in the four corners of the sensor's base to fix it to a wall [15]. The hole
in the center of the base [14] is used for allowing the sensor's cable to access its
coaxial connector while it is wall mounted. It is also used by the "caddy" clip to
attach the sensor to ceiling T-bars. Connect the coaxial cable to the connectors
on the back of the receiver [10] and the sensor [16].
Simeon 501TI Transmitter/Microphones
Transmitter 501TI is a versatile hand held wireless microphone that can be in-
terfaced with a boom (headset) mic, as well as with other auxiliary audio inputs.
It can either be used as a handheld pass around, or worn at the waist or around
the neck in conjunction with a boom (headset) mic. It is recommended that you
charge the transmitters fully before its initial use.
Open the transmitter battery compartment [21] and insert two NiMH batter-
ies (supplied), taking care to observe the correct battery polarity.
posable (alkaline) batteries in combination with the charging system.
battery compartment are switches for changing the channel and signal strength
of the transmitter. No two transmitters within range of the same speaker should
be set to the same channel. It is recommended to have the power level set to
'High'. This will allow for six (6) hours of talk time. If battery life beyond normal
use is necessary, the power level can be set to 'Low'.
Caution: never use non-stan-
Plug in the receiver to charge
Never use dis-
Inside the
3