Delivery Scope; Intended Use; Technical Data - Bosch GDS 18 V-LI HT Professional Manual Original

OBJ_BUCH-1140-005.book Page 9 Monday, December 17, 2012 3:11 PM
 The battery is supplied partially charged. To ensure full
battery capacity, completely charge the battery in the
battery charger before using for the first time.
 Read the operating instructions of the battery charger.
 Apply the power tool to the screw/nut only when it is
switched off. Rotating tool inserts can slip off.
 When working with an application tool, pay attention
that the application tool is firmly seated on the tool
holder. When the application tool is not firmly connected
with the tool holder, it can come loose again and not be
controlled.
 The torque depends on the impact duration. The maxi-
mum achieved torque results from the sum of all indi-
vidual torques achieved through impact.
 Check the actually reached torque with a torque
wrench.
 To save energy, only switch the power tool on when using
it.
Symbols
The following symbols are important for reading and under-
standing the operating instructions. Please take note of the
symbols and their meaning. The correct interpretation of the
symbols will help you to use the machine in a better and safer
manner.
Symbol Meaning
Cordless impact wrench
Grey-marked area: Handle
(insulated gripping surface)
Article number
Read all safety warnings and all instruc-
tions
Before any work on the machine itself,
remove the battery
Always wear ear protection.
Movement direction
Reaction direction
Bosch Power Tools
Symbol Meaning
Right/left rotation
Low speed
High speed
Switching On
Switching Off
U Rated voltage
n No-load speed
0
n Impact rate
S
M Maximum torque according to ISO 5393
Metal
Ø Bolt size
Tool holder
Weight according to EPTA-Procedure
01/2003
L Sound power level
wA
L Sound pressure level
pA
K Uncertainty
a Vibration total value
h

Delivery Scope

Cordless impact wrench.
Battery, application tools and other accessories shown or de-
scribed are not part of the standard delivery scope.
A complete overview of accessories can be found in our ac-
cessories program.

Intended Use

The machine is intended for driving in and loosening screws
and bolts as well as for tightening and loosening nuts within
the respective range of dimension.

Technical Data

The technical data of the machine are listed in the table on
page 126.
Technical data determined with battery from delivery scope.
Please observe the article number on the type plate of your
machine. The trade names of the individual machines may
vary.
English | 9
1 609 92A 01J | (17.12.12)