Vornado SRTH Manual De Instrucciones página 5

Tabla de contenido
Idiomas disponibles

Idiomas disponibles

condition is detected (see How To Use "RESETTING YOUR
VORNADO HEATER," to determine how to check and
reset the heater on page 8).
Do not operate this product with any electronic speed-control
device on the same circuit.
Do not use heater to dry human or animal hair/fur or articles of
clothing.
CAUTION: In order to avoid a hazard due to inadvertent resetting
of the thermal cutout, this appliance must not be supplied through
an external switching device, such as a timer, or connected to a
circuit that is regularly switched on and off by the utility.
WARNING: Changes or modifications to this unit not expressly
approved by the party responsible for compliance could void the
user's authority to operate the equipment.
Note: This equipment has been tested and found to comply with the
limits for Class B digital device, pursuant to part 15 of the FCC Rules.
These limits are designed to provide reasonable protection against
harmful interference in a residential installation. This equipment
generates, uses and can radiate radio frequency energy and, if not
installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no
guarantee that interference will not occur in a particular installation. If
this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and
on, the user is encouraged to try to correct the interference by one or
more of the following measures:
IMPORTANT INSTRUCTIONS
READ ALL INSTRUCTIONS BEFORE USING THIS HEATER.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the receiver.
Connect the equipment into an outlet on a circuit different from
that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician for help.
This device complies with part 15 of the FCC Rules. Operation
is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) his device must accept
any interference received, including interference that may cause
undesired operation.
SAVE THESE INSTRUCTIONS
English
5

Capítulos

Tabla de contenido
loading

Tabla de contenido