Selecta VR 2000 Manual De Instrucciones página 27

MANUAL DE INSTRUCCIONES CODIGO 80247 REV A
J
.P. SELECTA s.a.
Marzo/2011
6.2.1.1 Coefficient
1) Move the cursor on to «Coefficient», then press ok and it will go into the wave-
length setting interface automatically.
2) Choose the wavelength you need by pressing [»] [«] and then press ok. It will
go into the coefficient setting interface.
3) Input the K coefficient
There are five zeros on the screen, the cursor is on the first one at the beginning. Press
[»] [«], the first zero will vary between «0~9». Choose the number or symbol you
need, then press ok to confirm, the cursor then moves to the next zero automatically.
The second to the fifth bits vary between «0~9» and decimal point (it's between 9
and 8). Complete other bits of K Coefficient in the same way.
4) Input the B coefficient
When the last bit of K value is confirmed and Ok pressed, the interface goes into the
B Coefficient setting interface.
The first bit is a symbol bit, and varies from «+» to «-». The other bits are number
bits. The way to Input B is the same as you have done with K.
After the last bit of B is confirmed, the curve will be displayed on the screen.
Autovía A2 Km 585.1 Abrera 08630 (Barcelona) España
e-mail: [email protected] - website: http://www.jpselecta.es
(Sujetas a modificaciones sin previo aviso) Pag.: 27
Tel 34 93 770 08 77 Fax 34 93 770 23 62