Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Description
The Threadlocker Kit is intended to reduce loosening
of fasteners due to shock, vibration, and dynamic load.
These instructions describe the installation of the new
components. New fasteners were intended to be
blackened as an indicator that the Shear 30T has
been retrofitted.
Other Publications
For additional information on safe operation and
maintenance procedures, refer to the instruction
manuals listed below:
•
Publication 52084433 – Shear 30T Shearing Station
Keep this manual available to all personnel.
Replacement manuals are available upon request at no
charge at www.greenlee.com.
Do not discard this product or throw away!
For recycling information, go to www.greenlee.com.
All specifications are nominal and may change as design
improvements occur. Greenlee Tools, Inc. shall not be liable for
damages resulting from misapplication or misuse of its products.
Loctite
is a registered trademark of Henkel Corporation
®
KEEP THIS MANUAL
New Components
Key Part No. Description
52087052 Threadlocker Kit................................. 1
1
Screw, 3/8-16 x 5/8, Hex ................... 3
2
Screw 3/8-16 x 3/4 ............................ 4
3
Screw, 3/8-24 x 7/8 ........................... 4
4
Screw, 3/8-16 x 1-5/8, EGL Flange ... 1
5
Screw, 1/4-20 x 5/8, Flathead ........... 2
6
Screw, 1/4-20 x 1-1/4, SEMS ............ 1
7
Screw, 3/8-16 x 1-1/4 ........................ 3
8
Screw, 3/8-16 x 7/8 ........................... 3
9
263 Loctite
Tools Required
•
Torque wrench (up to 35 ft-lbs)
•
Hex driver (3/16" & 5/16")
•
9/16" & 5/8" hex wrench
Greenlee Tools, Inc.
Threadlocker Capsule .. 1
®
Installing New Components
Before installing new components:
•
Unplug electrical power
•
Release hydraulic pressure
•
Disconnect the hydraulic hose from cutting unit
1. Remove the 3 hex screws from the bottom of the
cassette (Fig. 1).
2. Apply Loctite
as shown in Fig. 2 and tighten them back to the
bottom of the cassette with 35 ft-lbs of torque.
Qty
3. Remove the screws for the rails (3) and the screw for
the cylinder frame (2) as shown in Fig. 3.
3
2
4455 Boeing Dr. • Rockford, IL 61109-2988 USA • 815-397-7070
Shear 30T Threadlocker Kit
Figure 1
(9) onto new hex screws (1) provided
®
Figure 2
2
Figure 3
Tabla de contenido
