Operation - Husqvarna 325iLK Manual Del Usuario

To disassemble the two-piece shaft
1. Turn the knob 3 turns or more to loosen the
coupling.
2. Push and hold the button (C).
3. Hold tight in the end of the shaft that the motor is
attached to.
4. Pull the attachment out of the coupling.
C
Introduction
WARNING: Read and understand the safety
chapter before you use the product.
To connect the battery to the product
WARNING: Only use Husqvarna original
batteries with the product.
1. Make sure that the battery is fully charged.
1386 - 002 - 04.12.2019
To install the suspension ring if
applicable
1. Install the suspension ring between the arrows on
the rear handle and the loop handle.
Note: Do not put the loop handle on the decal.
2. Adjust the ring to make the product balanced, and
easy to use.

Operation

2. Push the battery into the battery holder of the
product. The battery locks into position when you
hear a click.
3. Make sure that the battery is installed correctly.
CAUTION: If the battery does not move
easily into the battery holder, the battery
is not installed correctly. This can cause
damage to the product.
11