Operating Hints - Super Ego SEH019400 Manual Del Usuario

suction area from sinking into the bottom.
− Damaged supply lines must be replaced by
the manufacturer or technical assistance
service, or else, by a qualified engineer.
− Please note
current regulations
caused by this type of equipment, the
manufacturer will not be held liable
for damages in the following cases:
- Pump repairs have been carried out
in non authorised shops;
- non-original spares have been used.
− Same regulations apply for accessories.

Operating hints

− Dry-running operation causes increased
wear and is to be avoided. Therefore, the
pump must be immediately switched off
when water fails to flow.
− The pump is automatically switched off on
overheating by the built-in thermal motor
protector. After having cooled down, the
motor automatically switches on again.
(reasons and remedy, see Trouble Shooting
Guide, point I i).
− In order to unplug, pull the plum shell not
the power cable.
− The power cable (I) must not be used for
mounting or relocating the pump For
submerging or lifting/securing the pump. fix
a rope to the carrying handle (2).
− After having pumped chlorinated swimming
pool water or other liquids leaving residues,
the pump should be rinsed with clear water.
− Sand and other abrasive material in the
liquid cause increased wear and reduce the
pump's output.
− Avoid running of the pump for more than
10 min, against closed delivery side of the
pump.
− The Submersible pump sucks off down to
a residual water height of approx. 5mm.
This flat suction height of approx. 5mm.
This flat suction height is only reached in
case of manual operation (see point 5.
"Operation"), but not In case of automatic
operation.
− The Submersible Pump is equipped with an
automatic deaerating device whose function
12
that in accordance
involving damages
is to remove probable air licks in the pump.
If the water level drops below the vent valve
(4), some water flows penetrates outside
through the vent valve. This I not a defect
with or your pump, but serves to deaerate the
pump.
− If in case of manual operation the pump has
sucked off completely and water flows again
after the pump operation, the pump isn't
deaerated automatically. Then, the pump
has to be switched off for a short time and
then switched on again.
Maintenance. Care and storage
Submersible pumps are virtually maintenance-free.
In case of contamination inside the pump, the suction
base (6) can be taken off by unscrewing the 3 cross
recessed head screws.
Thus the turbine space can be cleaned. For safety
reasons a damaged turbine can only be exchanged
by the Service Centre.
CAUTION!
Repairs on electrical parts should only be
done by our Service Centres.
To protect the pump from frost damage,
store the pump in a dry place.
Safety and approval
Submersible Pumps are manufactured in accordance
with the current electrical safety regulations of the
Appliance Safety Law (GSG) and inspected by the
TUV (German institution for technical surveyance).
We expressly point out-that in accordance with
product liability law-we are not liable for damage
caused by our equipment if it is due to improper
repair or if parts have been exchanged not using
our Original parts or parts approved by us and if
the repairs were not carried out by the Technical
Service. The same applies to supplementary parts and
accessories.
ENGLISH