Flint & Walling PB0508S031 Manual De Instrucciones De Operación Y Partes página 7

Installation (Continued)
!
Ground motor
before connecting
to electrical power
supply.
Failure to
ground motor can
cause severe or
Hazardous
fatal electrical shock
voltage. Can
hazard.
shock, burn or
cause death.
Do not ground
Ground pump
to a gas supply line.
before connecting
to power supply.
Proper rotation of
pump impeller is
critical on three
phase motors. See Motor Rotation
under Operation section and Figure 12.
WIRING
1. Install, ground, wire and maintain
this pump in accordance with
your local electrical code and
all other codes and ordinances
that apply. Consult your local
building inspector for local code
information.
2. Ground the pump permanently
using a wire of size and type
specified by local or United States
National Electrical Code. Do not
ground to a gas supply line.
3. Connect ground wire first.
Connect to ground first, then to
green grounding terminal provided
on the motor frame, identified as
GRD. Ground connection MUST
be made to this terminal. Do not
connect motor to electrical power
supply until unit is permanently
grounded; otherwise serious or
fatal electrical shock hazard may
be caused.
4. Connect the other end of the
ground wire to a properly
grounded service panel or to a
control panel ground bar if it is
connected to the power supply
ground.
IMPORTANT: Check local and/or
United States National Electric Codes
for proper grounding information.
Make certain that
the power supply
conforms to the
electrical specifications of the motor
supplied. See Motor Data Charts.
Copyright © 2014 FLINT & WALLING, INC. • 95 North Oak St. • Kendallville, IN 46755
Pump used to boost incoming pressure from a wall hydrant (manual operation).
Hose Adapter
Wall Hydrant
High Pressure Reinforced Hose
Figure 8
115 VOLT
SINGLE PHASE
LINE
L1
A
Y W G
E H R
L I A
L T Y
O E
W
NOTE: Dual voltage motors, change the red and
gray wire to the voltage required.
Figure 9 - Wiring Diagram for Single Phase 1/3 - 2 HP
Motors
L1
Y
E
L
L
O
W
NOTE: Single voltage (230V) motor, and can not
be connected to 115V.
Figure 10 - Wiring Diagram for Single Phase
3 HP Motors
7
flintandwalling.com
Pressure Gauge
Pressure
Relief Valve
Service Tee
Inlet
Outlet
Spray
Nozzle
High Pressure Reinforced Hose
230 VOLT
SINGLE PHASE
L1
B L2 A
R T Y W
E A E H
D N L I
L T
O E
W
230 Volts
Single Phase
LINE
L2
A B
Hose Adapter
IL0424
LINE
B L2
G R T
R E A
A D N
Y
IL0180
G
R
A
Y
IL0181