Flint & Walling PB0508S031 Manual De Instrucciones De Operación Y Partes página 6

Installation (Continued)
5. A pressure gauge installed in
the inlet pipe close to the inlet
port, (See Figure 6) will show if
enough water is being supplied
to the pump. See Operation
Section - Priming, Pressure Boost
Installations.
6. On installations that are using
nozzles for mist spraying, install
a filter in the discharge plumbing
to prevent the nozzles from
becoming plugged. Multiple filters
should be plumbed in parallel.
Install a pressure
!
relief valve on any
installation where
pump pressure can exceed the pressure
tank's maximum working pressure or
on systems where the discharge line
can be shut off or obstructed. Extreme
over pressure can result in personal
injury or property damage.
This unit is not
waterproof and is
not intended to be
used in showers, saunas or other
potentially wet locations. The motor is
designed to be used in a clean dry
location with access to an adequate
supply of cooling air. Ambient
temperature around the motor should
not exceed 104ºF (40ºC). For outdoor
installations, motor must be protected
by a cover that does not block airflow
to and around the motor. This unit is
not weatherproof nor is it able to be
submersed in water or any other
liquid.
To avoid dangerous or fatal
electrical shock, turn off power to
motor before working on electrical
connections.
Supply voltage must be within ±
10% of nameplate voltage. Incorrect
voltage can cause fire or seriously
damage motor and voids warranty. If
in doubt, consult a licensed electrician.
Use wire size specified in wiring
Chart F. If possible, connect pump
to a separate branch circuit with no
other appliances on it. If motor wiring
diagram differs from diagram shown
below, follow diagram on motor.
Copyright © 2014 FLINT & WALLING, INC. • 95 North Oak St. • Kendallville, IN 46755
Pump used to boost incoming city pressure (automatic operation).
Street Supply
Union
Gate/Ball
Valve
(Normally
open)
Check
Pressure
Valve
Gauge
Union
Figure 6
IMPORTANT: A contained air pressure tank and pressure switch is required to
keep the pump from rapid cycling and prevent the motor from over heating.
Install the tank and switch on the house side of system.
Pump used to boost water pressure in mist spray applications (automatic
operation).
Pressure
Relief
Valve
Figure 7
NOTE: Install solenoid valve on discharge side of pump.
IMPORTANT: Clean all filters and strainers on a regular schedule.
6
flintandwalling.com
Gate/Ball
Check Valve
Valve
(Normally
open)
To size tank
properly - Match
drawdown of
tank to capacity
of pump
Service Tee
Inlet
Outlet
Pressure Switch
Pressure
Switch
Drain
Fuse Box
or Switch
Pressure Gauge
Thermostat
Line Filter
Solenoid
Valve
To Drain
Main Power Box
Fuse
Box or
Switch
Union
Pressure
Gauge
IL0422
Pressure
Relief
Valve
Gate/Ball Valve
From Water Source
Gate/Ball Valve
(Normally open)
To Nozzles
IL0423