Replacing The Air Cleaner; Changing The Engine Oil - Toro Recycler 20332C Manual Del Operador

Replacing the Air Cleaner

Service Interval: Every 25 hours
1. Use a screw driver to open the air filter cover
(Figure 19).
2. Replace the air filter (Figure 19).
3. Install the cover.
Figure 19

Changing the Engine Oil

Service Interval: After the first 5 hours
Yearly
Run the engine a few minutes before changing the oil
to warm it. Warm oil flows better and carries more
contaminants.
1. Move the mower to a level surface.
2. Refer to Preparing for Maintenance.
3. Remove the dipstick (Figure 20).
1. Dipstick
4. Tip the mower onto its side with the air filter up
to drain the used oil out through the oil fill tube
(Figure 21).
5. Return the mower to the operating position.
6. Pour about 3/4 of the crankcase capacity of oil in
the crankcase.
7. Wait 3 minutes for the oil to settle.
8. Wipe the dipstick clean with a clean cloth.
9. Insert the dipstick fully into the oil fill tube, then
remove the dipstick.
10. Read the oil level on the dipstick.
Note: If the oil level is below the Add mark on the
dipstick, slowly pour a small amount of oil into the
oil fill tube and repeat steps 8 through 10 until the oil
level is at the Full mark on the dipstick (Figure 20).
Important: Do not overfill the crankcase with
oil and run the engine. Drain the excess oil until
the oil level on the dipstick reads Full.
11. Install the dipstick into the oil fill tube securely.
12. Dispose of the used oil properly at a local recycling
center.
14
Figure 20
Figure 21