Maxon T-330 Manual Del Usuario página 11

CHANGING TAILLIGHT MOUNTING FASTENERS
NOTE: To allow access to taillight bulbs after Liftgate is installed, changes to taillight
mounting fasteners should be made before mounting Liftgate on pickup bed. If
taillight fasteners are accessible through the frame mounting brackets, it may not
be necessary to change the taillight fasteners.
1. Remove original taillight screws from
RH taillight lens (FIG. 11-1).
2. Drill a 9/64" hole through each taillight
lens and internal sheet metal (FIG.
11-1).
3. Drill a 3/16" hole through each taillight
lens only, for screw clearance (FIG.
11-1).
NOTE: Silicone sealant is not supplied
with installation kit.
4. Apply clear silicone sealant to the 3/16"
holes in the taillight lenses and threads
of self-tapping screws.
5. Install a self-tapping screw (Kit item)
into each 9/64" hole to hold the tail-
light lenses in place (FIG 11-1). Do not
overtighten.
LIFT CORPORATION Sht. 11 of 58 DSG#
M-14-25
ORIGINAL TAILLIGHT
SCREWS
FACTORY TAILLIGHT
SCREW
(4 PLACES)
MODIFYING TAILLIGHT MOUNTING
Rev. E Date: 08/13/19
MAIN FRAME MOUNTING
BRACKET (REF)
RH TAILLIGHT
LENS
DRILLED
HOLE
SELF-TAPPING
SCREW
(2 PLACES)
FIG. 11-1