SPORT-ELEC SPORT PRO Manual Del Usuario página 16

STEP 3 : Selecting the program
Programs on the left (SPORT programs
If you choose the SPORT programs
To choose HEALTH programs
Scroll through the programs by pressing the
displaying the corresponding program number at the top.
To go back, press the
You have now chosen the muscle zone(s) to be stimulated, and the program.
STEP 4 : Choose the "Warm-up phase"
(only for programs PG02 to PG07).
The " " pictogram blinks in the top right corner.
-
WARM UP PHASE
The screen proposes a warming-up phase before starting the active phase of the program.
To select it, press "OK, otherwise press the
Then the pictogram blinks.
To select " ", press the
ALT
If no key is pressed, the "
If you have selected the warm-up phase, "
is only in the simultaneous mode.
The screen is displayed : the battery level, phase duration (countdown in minutes), timer pictogram, the
" or " " option and warm-up phase if you have selected them.
"
ALT SIM
The pictogram for the program chosen is lit, the muscle zone(s) chosen blink alternately.
STEP 5 : • Launching the start - Adjusting intensity
Then, press the + buttons of the intensity keys matching the wires connected to your electrodes or your belt to
start the program.
If the battery is low, do not start the program.
The power level(s) are displayed at the bottom of the screen. The intensities vary during the session according
to the program's content.
A long press on the "C" key returns the power rapidly to 0.
• Program performance :
• Use of the "C" (Clear) key:
During the program, press the "C" key during a phase to set its time to zero. The next phase starts unless you
have reached the end of the program. In this case, this key allows returning to selecting the 1st muscle zone
(as at normal end of program).
• Disconnecting the electrodes during the program:
If an electrode is disconnected, the channel concerned is reset to O0 and blinks for 30 sec, before returning
to a fixed O0.
During these 30 sec, the electrode(s) can be reconnected, and power restored to the level required.
) blink.
, validate "OK".
, press the
key.
key, and validate "OK (it disappears from the screen).
key, to select " ", press the
SIM
" mode is imposed by default by the "OK" key.
SIM
" is displayed when starting the program, as the warm-up phase
SIM
key and validate "OK".
key. The screen first displays the 1st lower pictogram while
and option
key, then validate "OK".
- 22 -