Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Setting the Deck Wheels
Move the tractor on a firm and level surface, preferably
pavement, and proceed as follows
1.
Select the height position of the cutting deck by placing
the deck lift pedal in the normally desired mowing height
setting.
2.
Check the deck wheels for contact or excessive clearance
with the surface below. The deck wheels should have
between ¼-½" clearance above the ground.
3.
If the deck wheels have excessive clearance or contact with
the surface, adjust as follows:
a.
Raise the deck lift pedal to its highest setting.
b.
Remove the front and rear deck wheels by removing
the lock nuts and shoulder bolts which secure them
to the deck. See Fig. 6-6.
Lock Nut
Shoulder Bolt
NOTE: The 42" Decks do not have four wheels. There is one
wheel on the front right of the deck and one on the left
rear of the deck.
c.
Place the deck lift pedal in the desired mowing
height setting.
d.
Reinsert the shoulder bolts (with each gauge wheel)
into the index hole that leaves approximately
½-inch between the bottom of the wheel and the
pavement.
Parking Brake Adjustment
If the tractor does not come to a complete stop when the brake
lever is completely engaged, or if the tractor's rear wheels can
roll with the parking brake applied (and the hydrostatic relief
valve open), the brake is in need of adjustment. See your Cub
Cadet dealer to have the brake properly adjusted.
24
S
6— M
ection
aintenance
Deck Wheel
Figure 6-6
& a
djuStMentS
Capítulos
Tabla de contenido
Solución de problemas
