Cub Cadet RZT-S Manual Del Operador página 11

Adjusting the Seat
To adjust the position of the seat, lift the seat adjustment lever
up. Slide the seat forward or rearward to the desired position;
then release the adjustment lever. Make sure seat is locked into
position before operating the tractor. See Fig. 3-6.
Figure 3-6
Lower Deck Discharge Chute Deflector
WARNING!
Never operate the mower deck
without the chute deflector installed and in the
down position.
46" & 50" Decks
Check the mower deck for a shipping brace (with tag) that may
be holding the chute deflector upward for shipment. If a brace
is present, it must be removed before operating the tractor.
Holding the chute deflector fully upward, remove the shipping
brace by grasping it and rotating it clockwise. Lower the chute
deflector. See Fig. 3-7.
Shipping
Brace
Shipping
Brace
Figure 3-7
42" Decks
The discharge chute deflector must be installed before operating
the mower.
1.
2.
3.
50" Deck
Discharge
Deflector
46" Deck
Remove the keys that are attached with a zip tie to the
chute bracket.
Remove the flange lock nuts from the deck. Do not remove
the push nuts or carriage bolts, leaving them in place will
aid in installing the chute. See Fig. 3-8.
Flange Lock Nuts
Push Nuts
Carriage Bolts
Figure 3-8
Install the discharge chute deflector using the carriage
bolts, push nuts and flange lock nuts as shown in Fig. 3-9
and securely tighten the hardware.
Flange Lock Nuts
Chute
Push Nuts
Figure 3-9
S
ection
Carriage Bolts
3 — A & S -U
SSembly et p
11