Important - JANE MATRIX PLATFORM Instrucciones

1 Installing the platform in
the vehicle
1a -
Place the platform on the vehicle seat
with the anti-swivel leg (2) unfolded.
1b -
Take the ISOfix fasteners out (3) turning
the button (6) on the front of the base.
1c -
Slide both fasteners (3) towards the ISOfix
axes of your vehicle and press until both
sides are locked in place. Two green in-
dicators in the display(14) of the release
buttons (4) show that they are correctly
fastened. If one or both indicators are
red, try it again.
1d -
Turn the button (6) to position the platform
against the backrest of the vehicle.
1e -
Adjust the height of the leg (2) so that it is
supported by the floor of the vehicle, the
indicator on the base of the leg (7) will
turn green.
Removing the platform
1f -
Loosen the platform by turning the
button (6).
1g -
Release the ISOfix fasteners by turning
the buttons (4), the button indicator will
turn red. Remove the platform.
1h -
To fold the leg up (2), first slide the fol-
22
ding catch (15).
2 Installing the MATRIX LIGHT 2
baby carrier on the platform
2a - The MATRIX LIGHT 2 baby carrier should
be installed on the platform in one of the
two loading positions (positions 1 or 3).
2b - First insert the front pivots of the Matrix
Light 2 baby carrier into the two forks (12)
of the platform.
2c -
Drop the baby carrier so it locks into place
with the Pro-Fix fasteners (13).
2d -
Check that both sides are secure, the indi-
cator should turn green.
2e -
If you are going to use the baby carrier in
the sitting position (position 2), pull the
handle to release the swivel (5) and turn
to the facing backwards position. You will
only be able to turn the baby carrier if the
backrest is in its highest position. Lastly,
turn the carrying handle to the AUTO
position.
IMPORTANT: If you are going to use the
baby carrier in the lying down position (si-
deways), make sure that the backrest is in
the lowest position.
3 -