Important Notice - PRESIDIUM Gem Indicator PGI Manual Del Usuario

When the probe tip is pressed against the Calibration
Disk (Fig. 5.5a), the display screen will show the process
of calibration (Fig. 5.5b). Calibration is done for each
Calibration Disk when the display screen shows the
completed calibration meter and the word "Successful"
appears on the screen (Fig. 5.5c).
1
2
Fig. 5.5a
Fig 5.5 (a), (b) & (c) exhibit the steps of
calibration using Disk 1 (gray disk)
You will be prompted to perform the same calibration
process with Disk 2 by pressing the probe tip against
Disk 2.
When calibration on both disks are done, you will
be prompted on the screen to press "Select" to exit
calibration mode (Fig. 5.7).
27
Fig. 1.10a
USE DISK ONE
DEPRESS TIP
PLEASE WAIT
CALIBRATING Fig. 5.5b
SUCCESSFUL
DEPRESS TIP Fig. 5.5c
Fig. 5.7
IV. IMPORTANT NOTICE
• Keep the tester dry. Precipitation, humidity, and all
types of liquids or moisture can contain minerals that
will corrode electronic circuits. If your tester does get
wet, remove the battery, and allow the tester to dry
completely before replacing it.
•
Do not use or store the tester in dusty, dirty areas.
Its moving parts and electronic components can be
damaged.
• Do not store the tester in hot areas. High temperatures
can shorten the life of electronic devices, damage
batteries, and warp or melt certain plastics.
• Do not store the tester in cold areas. When the tester
returns to its normal temperature, moisture can form
inside the device and damage electronic circuit
boards.
• Do not attempt to open the tester other than as
instructed in this handbook.
• Do not drop, knock, or shake the tester. Rough
handling can break internal circuit boards and fine
mechanics.
• Do not use harsh chemicals, cleaning solvents, or
strong detergents to clean the tester.
• Do not paint the tester. Paint can clog the moving parts and prevent proper operation.
• If the tester is not working properly, kindly contact our
Customer Service at [email protected]
• To ensure optimal use of the product, users are strongly
advised to periodically check http://omi.presidium.com.sg
for relevant firmware updates.
Thank you for taking time to go through the user handbook
which will enable you to understand your recent purchase
better.
Presidium also recommends that you register your
warranty by sending the warranty registration card to us
or registering online at http://www.presidium.com.sg/
28