Range Hood Controls; Range Hood Care; Range Hood Lamps; Cleaning - Kitchen Aid KVWC908KSS Manual De Instrucciones

Range Hood Controls

Operating the Light
1. Press the light control buttons (C) to turn on and control the
light settings.
2. To select a lower intensity, press the left of the two light
control buttons until desired light setting. To increase, press
the right button.
Operating the Fan
1. Press the fan speed control buttons (A) to turn on and
control the fan settings.
2. To boost the fan speed for fi ve minutes, press the Fan Boost
level button (B). Once the fi ve minutes have passed, the fan
will return to the previously selected speed.
Auto On Fan
The range hood has a built in sensor to automatically turn the
fan on when excessive heat is detected.
If needed, the sensor will turn the fan to the Boost setting, and
once the heat decreases, the fan will automatically turn off.
Thermal protector
The range hood is equipped with a thermal protector to avoid
overheating conditions. If the range hood shuts off while in use,
press OFF button to turn off the range hood. Wait approximately
60 minutes, then press ON to restart the range hood.

RANGE HOOD CARE

Range Hood Lamps

Replacing a LED Lamp
Turn off the range hood and allow the LED lamp to cool. To
avoid damage or decreasing the life of the new lamp, do not
touch lamp with bare fi ngers. Replace lamp, using tissue or
wearing cotton gloves to handle lamp.
If new lamps do not operate, make sure the lamps are inserted
correctly before calling service.
1. Disconnect power.
2. Push up on the lens and turn it counterclockwise.
3. Remove the bulb and replace it with a 120 V, 6.5 W
maximum LED bulb with a GU10 base. Turn it clockwise to
lock it into place.
4. Repeat steps 2-3 for the other bulb if needed.
5. Reconnect power.
14

Cleaning

IMPORTANT: Clean the hood and grease fi lters frequently
according to the following instructions. Replace grease fi lters
before operating hood.
Exterior surfaces:
To avoid damage to the exterior surface,do not use steel wool
or soap-fi lled scouring pads. Rub in direction of the grain line to
avoid scratching the surface.
Always wipe dry to avoid water marks.
Stainless Steel Cleaner and Polish.
■
Mild liquid detergent and water.
■
Wipe with damp soft cloth or nonabrasive sponge, then rinse
■
with clean water and wipe dry.
Metal Filters and Drip Trays:
Use 2 hands to remove fi lters. Grasp fi lter handles, pull toward
the front of range hood and pull down on the rear handle to
remove. Repeat for each fi lter.
A
Remove grease drip tray.
A
A. Drip tray
Grease fi lters should be cleaned using warm water, dishwashing
liquid, and a non abrasive brush. Dishwasher not recommended.
Replace grease drip tray.
Reinstall fi lters, grasp fi lter handles and place front edge of fi lter
into the hood. Push up on the back handle and set rear of fi lter
into the drip tray to secure. Repeat for each fi lter.
A
A. Grease fi lter
A. Grease fi lter