Ec Declaration Of Conformity; Model Designation - Denios FKL Manual De Instrucciones

Ocultar thumbs

página de 10

/ 10
Contenido
Tabla de contenido

Tabla de contenido

Idiomas disponibles

2. Use and intended purpose

The drum cart is used for the safe and convenient internal movement of 200 litre steel and

plastic drums,

and for placing the drums down on sumps and for dispensing.

The extendable handle for easier lifting means that less leverage is required.

3. Technical details

The drum trolley is manufactured from galvanized steel with two swivel castors with brakes and two large

rubber wheels.

4. Specifications

Safe working load: 300 kg

5. Operation

1. Position drum trolley in front of the drum to be transported (located on the ground or on collecting sump).

2. Pull out sliding supports and fasten to frame with wing nuts.

3. Incline drum trolley towards drum.

4. Slowly remove drum trolley and support with the foot, the prongs must grip under the drum.

5. The prongs must be located under the drum. Firmly remove drum trolley, the heavier the drum, the

more effort is required.

6. Release the wing nuts for transport and push in the sliding supports. Fasten wing nuts again.

7. For filling from the horizontal drum the locking rollers must be fastened.

6. Maintenance and servicing

Tip product, check the rollers for ease of movement and if necessary grease with commercial grease.

Check at regular intervals for any damage. In case of damage the product must not be further used!

Herewith we, the DENIOS AG, Dehmer Straße 58-66, D 32549 Bad Oeynhausen, declare that the product

complies with following guidelines.

Type:

Safe working load:

EC Directives

ATEX-directive 94/9/EC

Model designation

The conformity assessment procedure was carried out according to ATEX-directive 94/9/EC in compliance

with art. 8 (1) b ii). The corresponding papers and documents are desposited according to the ATEX directive

at the place named: TÜV NORD CERT GmbH & Co. KG, Am TÜV 1, D-30519 Hannover

Person responsible for documentation

Mr. Dr. Ing. R. Adenstedt

Head of engineering

Fasskarre FKL

128283, 164372, 180864, 180865