Operation; Important - Southland S-WFT-16022-[E] Manual Del Operador

Operation

• Save all instructions
A
Before Starting the Engine
WARNING
Before starting engine, read operator's manual. Become fa-
miliar with location and function of all controls. Know how to
stop the engine quickly.
Before attempting to start the engine, review the following
steps:
1. Unit has been assembled according to all assembly
instructions.
2. Unit has been inspected for any damaged or missing
components.
3. No parts are remaining in the carton.
4. Engine oil is at proper level.
5. Fresh, clean, regular-unleaded gasoline has been added
to fuel tank.
6. Spark plug wire is connected to spark plug.
7. Trimmer has been moved to desired location.
8. Trimmer is on level surface.
B
How to Start the Engine
DANGER
Never run engine indoors or in a poorly ventilated area. En-
gine exhaust contains Carbon Monoxide, an ODERLESS
and DEADLY gas.
WARNING
Debris thrown from Trimmer can cause severe eye damage.
Always wear ANSI compliant safety glasses or eye shields
when operating trimmer. If you wear eyeglasses, put an OSHA
certified Wide Vision Safety Mask over your eyeglasses.
WARNING
Before starting Trimmer, clean debris from holes in the recoil
starter cover.
1. Review ALL steps in the "BEFORE STARTING THE
ENGINE" section.
2. Push the throttle lever in the forward position.
(See Figure 6)
3. Push the Primer Bulb 3 times, waiting 2 seconds
between each push. (See Figure 7)
NOTE: Not required when re-starting a warm engine.
Questions? Call Toll Free at 1-800-737-2112
WARNING
Keep all bystanders, especially CHILDREN, away during op-
eration.
IMPORTANT: This unit's engine exhaust system is equipped
with a spark-arresting muffler. Tampering with or removing
the spark-arrestor violates section 4442 of the California
Public Resources Code as well as other applicable state and
federal law.
Stop
Slow
Start/Fast
Throttle Control
Lever
9 Copyright © 2008 MAT Engine Technologies, LLC
Operation
(Continued)
• Save all instructions
4. Firmly grip the Trimmer handle with your left hand,
(See figure 8)
5. Firmly grip the Recoil Starter Handle with your right hand.
(See Figure 8)
6. Pull the recoil starter slowly, until you feel tension in the
starter rope. Then quickly pull the recoil starter handle to
completely unwind the starter rope. DO NOT allow the
starter rope to snap back. Let the starter rope slowly re
wind as you hold the recoil starter handle.
7. If engine fails to start after three pulls, push the primer
button two times and again pull the recoil starter handle.
8. If engine fails to start after 5 or 6 more tries, see the
instruction in the "Troubleshooting Chart".
WARNING
Keep hands, feet, hair, and loose clothing away from any
moving parts. Avoid touching muffler and surrounding areas
– temperatures can exceed 150 degrees. Keep all safety
devices and shields in place.
WARNING
Never leave the Trimmer unattended while the engine is run-
ning.
C
How to Stop the Engine
Move the throttle lever completely back to the STOP posi-
tion. (See Figure 6)
D
How to Engage the Trimmer Head
1. Start the engine. Refer to "How to Start the Engine"
Section.
2. Press and hold the start lever against the handle.
(See Figure 9)
3. Press the trimmer head drive lever forward, until it locks
into position. (See Figure 9)
E
How to Disengage the Trimmer Head
Figure 6
Release the start lever (See Figure 9). This will release the
trimmer head drive lever and disengage the trimmer head.
WARNING
Trimmer line will continue to rotate for several seconds after
releasing the start lever. Use Caution.
Primer
Button
Figure 7
Questions? Call Toll Free at 1-800-737-2112
Recoil Starter
Handle
Handle
Start Lever
Trimmer Head
Drive Lever
10 Copyright © 2008 MAT Engine Technologies, LLC
Figure 8
Figure 9