Tabla de contenido
Idiomas disponibles
Idiomas disponibles
INSTALLATION
First Steps
High voltages capable of causing severe
injury or death by electrical shock are
present in this unit.
•
To reduce risk of electrical shock, disconnect power before
working on or around the system. More than one disconnect
switch may be required to de-energize the equipment.
•
Check local electrical and building codes before installation.
The installation must be in accordance with their regulations
as well as the most recent National Electrical Code (NEC) and
the Occupational Safety and Health Act (OSHA).
•
Wire pump system for correct voltage as shown on the motor
nameplate. A separate branch circuit is recommended.
•
These pumps are supplied with lead wires and are intended
to be hardwired using a junction box or other approved
enclosure. The pump includes a grounding conductor. To
reduce risk of electric shock, be certain that it is properly con-
nected to ground.
•
To avoid hazards when installing or servicing, install a double
pole disconnect near the pump installation.
•
The pump should only be used with liquids compatible with
pump component materials. If the pump is used with liquids
incompatible with the pump components, the liquid can
cause failure to the electrical insulation system resulting in
electrical shock.
•
Do not use the power cord for lifting the pump.
INSTALLATION
First Steps
1.
Remove electrical power to the panel and pump.
2. Check the existing electrical panel to ensure that breakers and wire gauges meet or exceed National
Electric Code (NEC) guidelines.
3. If water is present in the basin, drain it to the level of the intake using an external pump or vacuum. Dis-
pose of all septic in accordance with local, state, and national codes.
4. Disconnect the electrical quick-disconnect plug located inside the basin, if applicable.
5. Remove the bolts securing the existing assembly, if applicable.
6. Rotate the ball valve lever to the CLOSED position.
7.
Remove the existing pump assembly from the basin and set it aside.
2
Risk of bodily injury, electric shock,
or property damage.
•
This equipment must not be used by children or persons with
reduced physical, sensory, or mental abilities, or lacking in
experience and expertise, unless supervised or instructed.
Children may not use the equipment, nor may they play with
the unit or in the immediate vicinity.
•
Do not use this pump for pumping any liquid intended for
human consumption.
•
Equipment can start automatically. Always disconnect the
electrical power before servicing the pump.
•
An inoperative or malfunctioning pump could lead to flood-
ing, resulting in personal injury or property damage.
•
Do not run pump dry. Running dry will cause serious damage
to the pump.
•
Do not let the unit freeze. Freezing may cause cracking or
distortion that may destroy the unit.
•
Operation of this equipment requires detailed installation
and operation instructions provided in this manual, along
with the original installation/service manual for use with this
product. Read entire manual before starting installation and
operation.
•
End User should receive and retain manual for future use.
•
Keep safety labels clean and in good condition.
•
Wear safety glasses while installing or performing mainte-
nance on the pump.
Tabla de contenido
