Tabla de contenido
Idiomas disponibles
Idiomas disponibles
UNPACKING
AND REMOVING
SHIPPING
BOLTS
When removing the washer from the carton base, be sure to
remove the foam tub support in the middle of the carton
base. See drawing below.
If you must lay the washer down to remove the base
packaging materials, always protect the side of the washer
and lay it carefully on its side. DO NOT lay the washer on its
front or back.
To prevent internal damage during transport, the washer is
equipped with 4 shipping bolts and plastic retainers.
IMPORTANT:
•These shipping bolts and retainers MUST NOT be
removed until just before moving the washer into its final
position.
•These bolts and retainers MUST be removed before
operating the washer.
• Failure to remove shipping bolts and retainers may cause
severe vibration and noise, which can lead to permanent
damage to the washer.
NOTE: The cord is secured to the back of the washer with a
shipping bolt to help prevent operation with shipping bolts in
place.
Foam Tub
Support
Carton
Base
Shipping
Bolts
Power
Cord
J
1. Starting with the bottom 2 shipping bolts, use the included
wrench to fully loosen the 4 shipping bolts by turning them
counterclockwise.
\
Bolt
Assembly
HoleCap
,
2. Remove the bolt assemblies by wiggling them slightly
while pulling.
3. Locate the four hole caps included in the accessory pack
and install them in the shipping bolt holes.
NOTE: Save the bolt assemblies for future use. To prevent
damage to internal components, the bolt assemblies must
be installed when transporting the washer.
Capítulos
Tabla de contenido
