Overview Of The Spire 100 Beacon; Unpacking The Beacon; Table 1 Product Specifications - Federal Signal Spire 100 Beacon Manual De Instrucciones

Overview of the Spire
The beacon uses an LED light source to provide a reliable
signal with 25 selectable flash patterns. Use pattern 10 if you
will be utilizing an external flasher. The beacon may be flush
mounted, pipe mounted, or attached to brackets. Optional
plastic or aluminum mounting flanges are available. The light
can also be ordered with magnetic mounts or magnetic suction
mounts. The light can operate on a nominal 12 or 24 Vdc power
source. A waterproof connector socket is molded into the base.
Pre-terminated wires and connector parts are supplied to build
the power leads. Installer-supplied wire may be used to neatly
extend the power connection to the vehicle's harness without
butt splices. Optional branch guards and dust covers are also
available.
Input Voltage
Input Current
Flash rate
Height
Diameter
Weight
Approvals

Unpacking the Beacon

After unpacking the beacon, inspect it for damage that
may have occurred in transit. If there is damage, file a claim
immediately with the carrier, stating the extent of damage.
Carefully check all envelopes, shipping labels, and tags before
removing or destroying them. If installing a permanent mounted
beacon, ensure that the parts listed in Table 2 are included in
the package.
100 Beacon
Spire
®
Federal Signal www.fedsig.com
Installation and Maintenance Instructions
100 Beacon
®

Table 1 Product specifications

12-24 Vdc
0.6 A at 12 Vdc
0.3 A at 24 Vdc
See Table 4 on page 17 for a description
of the patterns.
Tall beacon:
7.10 inches (18.034 cm) with flange
6.15 inches (15.621 cm) tall without flange
Short beacon:
5.60 inches (14.224 cm) with flange
4.65 inches (14.351 cm) without flange
6.54 in with flange
5.22 in without flange
0.75-2.0 lb (0.34-0.91 kg)
Marked on product
7