Tabla de contenido
Remark:-
MP3 track format requirement:-
Bit rate : 32 kbps~320kbps, sampling rate : 32kHz, 44.1kHz and 48 kHz decodable
-
-
The performance of playing MP3 disc is various from the quality of recording disc and the method of recording.
Furthermore, the searching lead-time for MP3-CD is longer than normal CD due to difference format.
Playback of MP3 song via USB storage media or memory card
Connecting
The system is able to decode and playback all MP3 file which stored in the memory media
with USB connecting port or SD/MMC memory card.
1.
Set the system at standby mode first or other function except USB/SD mode.
2.
Plug-in the USB pen-drive with the face up & make sure it going into completely or insert
the memory card in the direction of the arrow as shown in the label on the underside of
the memory card slot cover. Insert straight without bending..
Connecting the USB upside down or backwards could damage the audio system
or the storage media (USB thumb driver/SD/MMC card). Check to be sure the
direction is correct before connection.
3.
Turn on the unit again by On/Standby button (6) and set press Function button (4) to select CD mode. Press Source
button (8) to change to USB or SD mode. The system will start reading the storage media automatically after
connecting, and LCD display (16) will show the total number of MP3 files being detected.
4.
Repeat the same playback procedure as playing CD/MP3 disc as above.
Remark
-
The system can detect and read the file under MP3 format only at USB or SD mode but not other music file format.
If connect the system to MP3 player via the USB socket,
-
MP3 player
may not
USB port does not support connection with USB extension cable and is not designed for communication
-
with computer directly
Due to ErP stage two requirement and protect the environment. The unit will switch to standby mode
-
automatically once no any music playing over 15 minutes.
Removing of USB or memory card
To remove the USB turn off the power or switch the function mode to either cd or tuner mode first. For USB port – un-plug
it by pulling out the USB socket directly. For memory card – pull out the SD/MMC card straightly without bending.
Setting the alarm
This unit able to set the alarm and wake up by buzzer, Ocean or bird sound
1
Set unit in standby mode.
2. Press and hold the "Folder down/Alarm" button (9) a second, the minute digit flashing on the LCD display (16). Press
skip up
or skip down
the correct minute.
3. The hour digit will flashing, press the skip up
press "Folder down/Alarm " button (9) to store the correct hour.
4. Choose the wake up sound mode by Alarm sound mode selector (25).
Active/de-active timer function
1.
Press the "Folder down/Alarm" button (9) repeatedly until the timer indicator is shown on LCD display (16).
2.
To cancel alarm function by press again "Folder down/Alarm" button (9) until the timer indicator disappear.
Remark : When alarm sound press " snooze " button (15) once to terminate the alarm mode temporarily and it will alarm
again after 9 minutes on each press. To cancel the alarm mode, press the "Folder down/Alarm" button (9). If no
any button press during alarm, it will automatically stop after running one hour.
The alarm setting will be automatically stored if no button is being pressed in a period of about 10 seconds
during alarm setting mode.
be able to play
via the
USB socket. This is not a malfunction of the system.
button (11) to set the correct minute. Press "Folder down/Alarm" button (9) to store
due to variances in MP3 encoding format, some
or skip down
button (11) to set the correct minutes. Then
4
Tabla de contenido
