Tabla de contenido
Idiomas disponibles
Idiomas disponibles
touched together.
See instructions for charging a battery inside a vehicle (Section 6) or outside of the
vehicle (Section 7).
ChARgINg
1. Ensure that all of the charger components are in place and in good working condition.
2. Connect the battery, following the precautions listed in sections 6 and 7.
3. Connect the AC power following the precautions listed in section 8.
4. When the charger starts, the gREEN lED will be solid, and the display will show
AnAlyzing BAttery while the charger determines that the battery is properly connected
and the condition of the battery.
5. When the battery is fully charged, the gREEN lED will pulse.
6. When charging is complete, disconnect the AC cord from the supply mains, remove the
clamp from the vehicle's chassis, and then remove the clamp from the battery terminal.
POWER SUPPlY
1. Ensure that all of the charger components are in place and in good working condition.
2. Connect the battery, following the precautions listed in sections 6 and 7.
3. Connect the AC power following the precautions listed in section 8.
4. When the power supply starts, the gREEN lED will be solid, and the display will show
POWer SUPPly On.
BATTERY CONNECTION INDICATOR
If the charger does not detect a properly connected battery, charging will not start and the digital
display will show one of two messages. If the display shows COnneCt ClAMPS, make sure
the charger is connected to the battery and the connection points are clean and making a good
connection. If the display shows WArning - ClAMPS reVerSeD, unplug the charger from
the AC outlet, reverse the connections at the battery, and then plug the charger back in.
BATTERY ChARgINg TIMES
BATTERY ChARgINg TIMES
BATTERY
APPlICATION
POWERSPORTS
AUTOMOTIVE
300 CCA
1000 CCA
MARINE
230 Ah
Times are based on a 50% discharged battery and may change,
depending on age and condition of battery.
AUTOMATIC ChARgINg MODE
When an Automatic Charge is performed, the charger switches to the Maintain Mode
automatically after the battery is charged. For a battery with a starting voltage under 1 volt, use a
manual charger to pre-charge the battery for five minutes, to get additional voltage into the battery.
ABORTED ChARgE
If charging cannot be completed normally, charging will abort. When charging aborts, the
charger's output is shut off, the gREEN lED will flash, and the display will show CHArge
ABOrteD - BAD BAttery. Do not continue attempting to charge this battery. Check the
battery and replace, if necessary.
ChARgE COMPlETION AND MAINTAIN MODE (FlOAT MODE MONITORINg)
Charge completion is indicated by the pulsing gREEN lED and the digital display showing
ChARgINg TIME (hours)
SIZE
6A
10A
6 Ah
2
1.5
32Ah
5
4
4
3
10
7
50 Ah
5
3.5
19
11.5
12A
15A
1
0.5
NOT
RECOMMENDED
3
2
2
1.5
5.5
4
2.5
2
9.5
7.5
•
•
8
Tabla de contenido
