Safety Warnings - Astralpool LumiPlus 1.11 RGB DMX Manual De Instalación Y Mantenimiento

5 projectors in the line
L. Projector (m)
LumiPlus 1.11
10 - 18
7 - 10
4 - 7
0 - 4
A modulator and projectors can be in the same line.
Do not install the 12V~AC power lines of the projectors and modulators near possible electrical interference of other
signals.

7. SAFETY WARNINGS:

• Avoid making contact with the electric voltage.
• Comply with the current standards regarding accident prevention.
• In this regard, the IEC 364-7-702 standards must be observed: WIRING IN BUILDINGS SPECIAL WIRING SWIM-
MING POOLS.
• All maintenance operations should be performed with the lamp disconnected from the Mains.
• Do not handle with wet feet.
• The manufacturer is not responsible in any circumstances for assembly, installation or start-up of any electric com-
ponents which have been inserted or handled at locations other than its own premises.
• The PAR56 lamp of LEDs withstands to the treatments of swimming pool described next as long as the values of
concentration do not surpass the following values:
Chlorine
Bromine
Salt electrolysis (Na Cl)
Attention : Please note that the Ph of pool water always must be between 7.2 and 7.6.
Section
LumiPlus 2.0
2
9 -12 10 mm
2
6 - 9
6 mm
2
2 - 6 4 mm
2
0 - 2 2,5 mm
TYPE OF TREATMENT
LumiPlus 1.11
Cu
0 - 9
Cu
Cu
Cu
CONCENTRATION IN WATER
4
10 projectors in the line
L. Projector (m)
LumiPlus 2.0
0 - 6
2 mg/l
5 mg/l
6 g/l
Section
2
10 mm Cu