Initial Operation; Electrical Connection - WarmPool SILENP-03 Manual De Instrucciones

The unit may be installed in virtually any outdoor location as long as the specified minimum distances to other
objects are maintained. Please consult your installer for installation with an indoor pool.
ATTENTION: Never install the unit in a closed room with a limited air volume in which the air expelled from the
unit will be reused, or close to shrubbery that could block the air inlet. Such locations impair the continuous supply
of fresh air, resulting in reduced efficiency and possibly preventing sufficient heat output.

3.2 Initial operation

Note: In order to heat the water in the pool (or hot tub), the filter pump must be running to cause the water to
circulate through the heat pump. The heat pump will not start up if the water is not circulating.

3.3 Electrical connection

Before connecting the unit, verify that the supply voltage matches the operating voltage of the heat pump.
The RCD plug has been included with power cable, which can offer electrical protection.
Attention:
Ensure the power plug is secure
If the plug is not secure, it may cause
an electric shock, over-heating or
fire
Never pull out the power plug during
operation
Otherwise, it may cause an electric
shock or a fire due to over-heating.
Never use damaged electric wires
or unspecified electric wires.
Otherwise it may cause an electric
shock or a fire.