Functional Description - Black+Decker LSW40 Manual De Instrucciones

FUNCTIONAL DESCRIPTION

1. On / Off Switch
2. Tube
or above +105°F (+40.5°C). This is important and will
prevent serious damage to the battery pack.
2. The charger and battery pack may become warm to touch
while charging. This is a normal condition, and does not
indicate a problem. To facilitate the cooling of the battery
pack after use, avoid placing the charger or battery pack
in a warm environment such as in a metal shed, or an
uninsulated trailer.
3. If the battery pack does not charge properly:
a. Check current at receptacle by plugging in a lamp
or other appliance
b. Check to see if receptacle is connected to a light
switch which turns power off when you turn out
the lights.
c. Move charger and battery pack to a location where
the surrounding air temperature is approximately 60°F-
80°F (16° - 27°C).
d. If charging problems persist, take the appliance,
battery pack and charger to your local service center.
4. The battery pack should be recharged when it fails
to produce sufficient power on jobs which were easily
done previously. DO NOT CONTINUE to use under these
conditions. Follow the charging procedure. You may also
charge a partially used pack whenever you desire with no
adverse affect on the battery pack.
5. Foreign materials of a conductive nature such as, but
not limited to, steel wool, aluminum foil, or any buildup of
metallic particles should be kept away from charger cavities.
Always unplug the charger from the power supply when
there is no battery pack in the cavity. Unplug charger before
attempting to clean.
6. Do not freeze or immerse charger in water or any other liquid.
WARNING:
SHOCK HAZARD. Do not
allow any liquid to get inside charger. NEVER
ATTEMPT TO OPEN THE BATTERY PACK FOR ANY REASON.
IF THE PLASTIC HOUSING OF THE BATTERY PACK BREAKS
OR CRACKS, RETURN TO A SERVICE CENTER FOR
RECYCLING.
SAVE THESE INSTRUCTIONS
STATE OF CHARGE
INDICATOR- FIGURE A
The back of the battery is equipped with a
state of charge indicator. This can be used
to display the current level of charge in the
battery during use and during charging.
It does not indicate tool functionality and
is subject to variation based on product
2
components, temperature and end-user
application.
CHECKING STATE OF CHARGE DURING USE:
• Press the state of charge indicator button
(A1).
• The three LED's (A2) will illuminate
indicating the percent of charge in the
battery. See chart in figure A.
• If LED light does not lluminate, charge
battery.
NOTE:
This
battery is
designed to
not operate
when a charge
below 20% of
its capacity is
reached. After
the battery
charge is
depleted, the
tool will not operate until after the battery
has been recharged.
TUBE ASSEMBLY
NOTE: Ensure the sweeper is switched off
and the battery is removed before attaching or
removing the sweeper tube. The tube must be
assembled to the housing before use.
• To attach the tube to the sweeper, line
up the tube with the sweeper housing as
shown in figure B.
• Push the tube into the sweeper housing
until the lock button (4) engages the lock
hole (5) in the tube.
B
6
1
A
A2
<18%
18% - 45%
45% - 72%
72% - 100%
4
5
A1