Troubleshooting - Philips NT9110 Manual De Instrucciones

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

ENGLISH

Introduction

Congratulations on your purchase and welcome to

Philips! To fully benefit from the support that Philips offers,

General description (Fig. 1)

A Cutting element

B Trimming head

C ^= 'Open' indication

D Setting indicator

E Battery compartment cover

F Motor unit

G 0 = 'Off ' indication

H I = 'On' indication

I Sealing ring

J Protection cap

K Short eyebrow comb (3mm/0.12in) (NT9110 only)

L Long eyebrow comb (5mm/0.2in) (NT9110 only)

M Brush (NT9110 only)

Important

Read this user manual carefully before you use the

appliance and save it for future reference.

Warning

This appliance is not intended for use by persons

(including children) with reduced physical, sensory

or mental capabilities, or lack of experience and

knowledge, unless they have been given supervision

or instruction concerning use of the appliance by a

person responsible for their safety.

Children should be supervised to ensure that they

do not play with the appliance.

Caution

This appliance can only be operated on a battery.

Do not use the appliance when the cutting element

or the appliance itself is damaged or broken, as this

may cause injury.

Use and store the appliance at a temperature

between 15°C and 35°C.

This appliance is only intended for trimming

nose hair and ear hair. With the eyebrow combs

(NT9110 only), you can also use the appliance to

trim eyebrows. Do not use it for another purpose.

Remove the battery from the appliance if you are

not going to use it for some time.

If the appliance is subjected to a major change in

temperature, pressure or humidity, let the appliance

acclimatise for 30 minutes before you use it.

For hygienic reasons, the appliance should only be

used by one person.

Electromagnetic fields (EMF)

This Philips appliance complies with all standards

regarding electromagnetic fields (EMF). If handled

properly and according to the instructions in this user

manual, the appliance is safe to use based on scientific

evidence available today.

Preparing for use

To remove the battery compartment cover, turn

it to the left until the setting indicator points

to the 'open' ( ^) indication. Then pull the battery

compartment cover off the motor unit. (Fig. 2)

Put the battery in the battery compartment (Fig. 3).

Make sure the + and - poles of the battery point in the

right direction.

Note: The appliance runs on one R6 AA 1.5-volt battery

(included). Preferably use Philips alkaline batteries. A new AA

alkaline battery has an operating time of up to 2 hours.

Slide the battery compartment cover back onto

the motor unit. Turn the cover to the right

until the setting indicator points to the 'off' (0)

indication (Fig. 4).

Make sure the sealing ring is properly placed (Fig. 5).

To avoid damage due to battery leakage:

do not expose the appliance to direct sunlight.

do not expose the appliance to temperatures higher

than 35°C.

remove the battery if you are not going to use the

appliance for a month or more.

do not leave an empty battery in the appliance.

Using the appliance

Remove the protection cap by pulling it off the

appliance (Fig. 6).

To switch on the appliance, turn the battery

compartment cover to the right until the setting

indicator points to the 'I' indication (Fig. 7).

Before you use the trimmer for the first time, test

it on a small part of your arm or leg.

If any irritation or allergic reaction occurs, discontinue

use immediately. Do no use the trimmer on sensitive or

irritated skin.

Use the appliance as described in the rest of this

chapter.

To switch off the appliance, turn the battery

compartment cover to the left until the setting

indicator points to the '0' indication (Fig. 8).

Put the protection cap back onto the cutting

element after use to prevent damage.

Trimming nose hair

Make sure your nostrils are clean.

Carefully insert the cutting element into one of

your nostrils.

Do not insert the cutting element more than 0.5cm

into your nostrils.

Slowly move the appliance around to remove all

unwanted hairs in your nostrils (Fig. 9).

Trimming ear hair

Make sure your outer ear channels are clean and free

from wax.

Slowly move the cutting element along the rim of

the ear to remove hairs that stick out beyond the

rim (Fig. 10).

Insert the cutting element into the outer ear

channel.

Do not insert the cutting element more than 0.5cm

into your ear channel, as this could damage the

eardrum.

Slowly turn the appliance around to remove

all unwanted hairs from your outer ear

channel (Fig. 11).

Trimming eyebrows (NT9110 only)

With the short and long eyebrow combs, you can use the

appliance to trim your eyebrows to a uniform hair length.

Comb your eyebrows in the direction of hair

growth (Fig. 12).

Choose the short or long comb, depending on the

desired hair length. The indications 'short' and 'long'

are on the combs.

short comb: 3mm/0.12in

long: 5mm/0.2in

Tip: We advise you to start trimming with the long comb.

If you think your eyebrows are still too long after this, use

the short comb.

Slide the eyebrow comb onto the cutting element.

Make sure that the eyebrow comb has been properly

slid into the grooves on both sides (Fig. 13).

To switch on the appliance, turn the battery

compartment cover to the right until the setting

indicator points to the 'I' indication (Fig. 7).

Move the comb over the eyebrow from the outer

tip of the eyebrow towards the base of the nose

(against the direction of hair growth) (Fig. 14).

Never try to trim your eyelashes. Keep the appliance

away from your eyes.

Cleaning

Clean the appliance immediately after use and when a lot

of hair or dirt has accumulated on the cutting unit.

Never immerse the base in water or rinse it under the

tap.

Never use compressed air, scouring pads, abrasive

cleaning agents or aggressive liquids such as petrol or

acetone to clean the appliance.

The trimming head cannot be opened or detached.

Do not tap on the cutting element.

Do not use any sharp objects to clean the cutting

element.

Note: The appliance does not need any lubrication.

Switch on the appliance.

Rinse the cutting element under the tap with hot

water (Fig. 15).

NT9110 only: You can also clean the cutting element

with the brush supplied. Pay extra attention to the

edges of the cutting element. (Fig. 16)

Tip: To remove all hairs, let the appliance run briefly and

then clean the cutting element with the brush again.

Switch off the appliance and let it dry.

NT9110 only: Clean the combs under the tap.

Replacement

NT9110 only: If the eyebrow combs are damaged or

worn, always replace them with original Philips eyebrow

combs, which are available from authorised Philips service

centres.

The cutting element cannot be replaced. If the cutting

element is damaged or worn, you must discard the whole

appliance (see chapter 'Environment') and replace it with

a new one.

Environment

Batteries contain substances that may pollute the

environment. Remove the battery when it is empty

or when you discard the appliance. Do not throw

away the battery with the normal household waste,

but hand it in at an official collection point (Fig. 17).

Do not throw away the appliance with the normal

household waste at the end of its life, but hand it in

at an official collection point for recycling. By doing

this, you help to preserve the environment (Fig. 18).

Guarantee and service

If you need service or information or if you have a

problem, please visit the Philips website at www.philips.

com or contact the Philips Consumer Care Centre

in your country (you find its phone number in the

worldwide guarantee leaflet). If there is no Consumer

Care Centre in your country, go to your local Philips

dealer.

Guarantee restrictions

The guarantee becomes invalid when the appliance is

not used and/or not maintained properly or when it is

damaged by dropping.