Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Assembly
The propane gas and cylinder are sold separately. Use a standard 20 lb. propane cylinder only. Use this fire table only
with a vapor withdrawal supply system. See Chapter 3 of the standard for storage and handling of liquefied petroleum
gas, ANSA/NFPA 58. Your local library or fire department should have this book.
Storage of an appliance indoors is permissible only if the cylinder is disconnected and removed from the appliance. A
cylinder must be stored outdoors in a well-ventilated area out of reach of children. A disconnected cylinder must have
all dust caps tightly installed and must no be stored in a building, garage or any other enclosed area. The maximum inlet
gas supply pressure: 250 psi. The minimum inlet gas supply pressure: 5 psi.
The minimum hourly rate of 10,000 BTUs is required input rating for a fire table for automatic
operation at rating less than full input rating.
The pressure regulator and hose supplied with the appliance must be used. The installation
must conform with local codes or in the absence of local codes, with national fuel gas code,
ANSI Z21.97-2014/CSA 2.41-2014, natural gas and propane Installation Code, CSA B1491.1, or
propane storage and handling code, B149.2.
A dented, rusted or damaged propane cylinder may be hazardous and should be checked by your
cylinder supplier. Never use a propane cylinder with a damaged valve connection.
The propane cylinder must be constructed and marked in accordance with the specifications for
LP gas cylinders of the U.S. Department of Transportation (DOT) or the standard for cylinders,
spheres and tubes for transportation of dangerous goods and commission, CAN/CSA-B339.
The cylinder must have a listed overfilling prevention device.
The cylinder must have a connection device compatible with the connection for the appliance.
The cylinder used must include a collar to protect the cylinder valve.
Never connect an unregulated propane cylinder to the appliance.
8. Connect Gas Tank
(I) Connect hose and regulator to cylinder. See Figure A.
(II) Turn the cylinder valve clockwise to close the gas supply on the gas
cylinder. Screw the regulator coupling clockwise by hand only. Make
sure it is fastened. See Figure B.
9. Install Cylinder. Put the cylinder into bottom Plate (E), buckle the
propane tank strap (II) and secure the cylinder by tightening the screw in
the bottom plate.
Standard 20 lb. tank
8
A
8
B
9
1-877-387-3639
|
Page 9
Tabla de contenido
