Adjusting The Miter Gauge - KNOVA KN RXW-10M2 Manual Del Usuario

ASSEMBLE AND ADJUSTMENTS
SWITCH
INSTALLATION:
Put screw A into
the front rail then
install the switch
plate and lock by
washer and hex. nut.
B
C

ADJUSTING THE MITER GAUGE

See Figure 25.
You can set the miter gauge at 0º and plus or minus 45º with
the miter gauge stop pin and adjustable stop screws.
Note: The miter gauge provides close accuracy in angled
cuts. For very close tolerances, test cuts
are recommended.
• Loosen knob and pull out on stop pin to rotate miter
gauge base past stop screws.
• Loosen the lock nut of the 0º stop screw at
the stop pin with a 8mm wrench.
• Place a 90º square against the miter gauge
rod and the miter gauge base.
• If the rod is not square, loosen the knob, adjust the rod,
and tighten the knob.
• Adjust the 0º stop screw until it rests against
the stop pin.
• Adjust the plus and minus 45º stop screws
using a 45º triangle and the steps above.
A
Fig. 23
gauge rod
Fig. 25
11
Miter
Miter
gauge base
45º
Adjustable
stop screw
Knob
0º
Lock
Adjustable
nut
stop screw