Rejuvenation Petrel Manual Del Propietário página 8

How to Assemble Your Ceiling Fan (continued)
6. Route wires and safety cable through motor coupling
cover, canopy trim ring assembly and ceiling canopy.
(Figure 6)
7. Reinstall the hanger ball on the downrod as follows.
Route the black/white, blue, red, gray, yellow wires
and safety cable through the hanger ball. Position the
pin through the two holes in the downrod and align the
hanger ball so the pin is captured in the groove in the
top of the hanger ball. Pull the hanger ball up tight
against the pin. Securely tighten the set screw in the
hanger ball. A loose set screw could cause fan
wobble. (Figure 7)
NOTE: All set screws must be checked, and retightened
where necessary before installation.
9. Completely remove one of each right-hand screw
on either side of the flap of the hanger bracket and
retain the screws for later. Loosen the remaining
screws without fully removing them. (Figure 9)
Ceiling
Canopy
Motor Coupling
Cover
8
Canopy Trim
Ring Assembly
Figure 6
Figure 7
Figure 8
Figure 9