How To Assemble Your Fan Blade - Rejuvenation Petrel Manual Del Propietário

Ocultar thumbs

Tabla de contenido

Idiomas disponibles

1. Lay flat side of blade holder on a flat surface with

the inside of the blade holder facing up. This is the

side with the threaded posts and pitched foot.

Position the blade over the blade holder with the

threaded posts showing. Make sure the bottom edge

of the blade is fully seated against the blade holder.

Place blade holder cover on top of the blade,

positioning the holes over the threaded posts. With a

Philips screwdriver, thread both screws into the posts

but do not fully tighten. Prior to final tightening,

position the centerline of the blade holder with the

center of the end of the blade. Tighten both screws to

secure the blade. (Figure 1)

NOTE: You will find the fan blade set packed in its own

carton.

Do not connect fan blades until the fan is completely

installed. Installing the fan with blades assembled

may result in damage to the fan blades.

2. Attach blade holders to the bottom of the fan

from the hardware bag. Make sure the screws

with lockwashers securing the blade holders to the

fan motor hub are tight and that the blade holders

NOTE: Periodically check Blade Holder hardware and re-

secure if necessary. (see Maintenance below)

WARNING

To reduce the risk of personal injury, do not bend the

blade holders when installing, balancing the blades or

cleaning the fan. Do not insert foreign objects in between

the rotating blades.