Tabla de contenido
Idiomas disponibles
Idiomas disponibles
This manual is designed to make it as easy as possible for you
to assemble, install, operate, and maintain your Rejuvenation ceiling fan.
Tools Needed for Assembly
• One Phillips head screwdriver
• One 1/4˝ flat head screwdriver
• One
hex wrench
• One stepladder
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 11). If you feel you
do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
For your convenience, check-off each step. As each step is completed, place a check mark. This will ensure that all
s
e t
p
s
h
a
v
e
b
e
e
n
c
o
m
Do not install or use fan if any part is damaged or
missing. This product is designed to use only those
parts supplied with this product and/or any accessories
designated specifically for use with this product by
Fanimation. Substitution of parts or accessories not
designated for use with this product by Fanimation could
result in personal injury or property damage. Contact
Rejuvenation at 888.567.2055 for missing or damaged
parts.
1. Check to see that you have received the following
parts:
NOTE: If you are uncertain of part description, refer to
exploded view illustration.
Hanger Bracket
Assembly
Downrod/Hanger Ball
Assembly
Ceiling Canopy
• Four wire connectors
• One wire stripper
WARNING
Unpacking Instructions
p
e l
e t
d
a
n
d
w
l l i
b
e
h
l e
f p
l u
WARNING
Canopy Trim
Ring Assembly
Motor Coupling
Cover Assembly
Motor Assembly
Wiring outlet box and box connectors must be of type
required by local code. The minimum wire would be a 3-
conductor (2-wire with ground) of the following size:
Installed Wire Length
NOTE: Place the parts from the loose parts bags in a small
container to keep them from being lost. If any parts are missing,
contact Rejuvenation technical support at 888.567.2055
n i
n i f
d
n i
g
y
o
r u
p
a l
c
e
s
h
o
u
• Motor Assembly
• Hanger Bracket Assembly
• Downrod/Hanger Ball
Assembly
• Ceiling Canopy
• Motor Coupling Cover Assembly
• Canopy Trim Ring Assembly
• Blade Holder Set
• Blade Holder Cover Set
• Light Plate Assembly
• LED Assembly
• Light Housing Assembly with Glass
• Receiver Unit
• Hand-Held Remote
Light Plate Assembly
LED Assembly
Light Housing Assembly
Blade Holder Set
4
Materials
Wire Size A.W.G.
Up to 50 ft.
50 - 100 ft.
d l
y
o
u
b
e
i
t n
r e
u r
p
e t
. d
• Hardware bags:
– Ten 1/4˝-20 Pan Head screws
with lockwashers
(blade holder to fan motor hub)
– Ten 3/16˝-24 Flat and Serrated
Head screw (blade to blade holder)
– Four wire connectors
– Bag Assembly Safety Cable
With Glass
Blade Holder Cover Set
14
12
Receiver Unit
Hand-Held Remote
Hardware Bags
Capítulos
Tabla de contenido
Solución de problemas
