How To Wire Your Ceiling Fan - Rejuvenation Petrel Manual Del Propietário

NOTE: If fan or supply wires are different colors than indicated, ha
1. To set the code on receiver unit, slide dip switches to
the same positions as set on the remote. (Figure 1)
NOTE: The remote unit has 32 different code
other remote units, simply change the combination code
NOTE: Factory setting is all up. Do not use this position.
WARNING
To avoid possible electrical shock, be sure electricity
is turned off at the main fuse box before wiring
(Figure 2).
NOTE: If you are not sure if the outlet box is
grounded, contact a licensed electrician for advice, as
CAUTION: INCORRECT WIRE CONNECTION COULD
DAMAGE THIS RECEIVER.
2. Slide the receiver into the hanger bracket before wiring
as shown in figure 3.
3. Connect wires using connectors as shown in Figure 4.
RECEIVER HARDWARE USED:
WIRE
CONNECTORS
Check to see that all connections are tight, including
ground, and that no bare wire is visible at the wire
connectors. Do not operate fan until the blades are in
place. Noise and motor damage could result.

How to Wire Your Ceiling Fan

x 8
WARNING
Dip Switch
ON
1 2 3
NOTE: Supply wires
omitted for clarity
Figure 4
11
4 5
Figure 1
MAIN FUSE BOX
Figure 2
Figure 3