Tools Needed For Assembly; Electrical Requirements - Emerson KEANE CF320BS00 Manual Del Usuario

1. Unpacking Instructions
This Manual Is Designed to Make it as Easy as Possible for You to Assemble,

Tools Needed for Assembly

One Phillips head screwdriver
Materials
One 1/4" blade screwdriver
Wiring outlet box and box connectors must be of type
required by the local code. The minimum wire would be a
3-conductor (2-wire with ground) of following size:
Installed Wire Length
Up to 50 ft.
50-100 ft.
Your new ceiling fan will require a grounded electrical
supply line of 120 volts AC, 60 Hz, 15 amp circuit.
The outlet box must be securely anchored and capable of
withstanding a load of at least 50 pounds.
WARNING
!
To reduce the risk of fire, electric shock, or personal
injury, mount fan to outlet box marked "Acceptable for
Fan Support of 22.7kg. (50 lbs.) or less", and use screws
supplied with outlet box. Most outlet boxes commonly
used for support of light fixtures are not acceptable for
fan support and may need to be replaced. Consult a
qualified electrician if in doubt.
WARNING
!
Turning off wall switch is not sufficient. To avoid possible
electrical shock, be sure electricity is turned off at the
main fuse box before wiring. All wiring must be in
accordance with National and Local codes and the ceiling
fan must be properly grounded as a precaution against
possible electrical shock.
Install, Operate and Maintain Your Ceiling Fan
One stepladder
One wire stripper
Wire Size A.W.G.
14
12

2. Electrical Requirements

(Continued)
Your Emerson Ceiling Fan comes supplied with a Fan Wall
Control. This system allows you to regulate your ceiling fan
speed.
This Emerson Ceiling Fan may be used with the following
accessories: RFCP Receiver and SR400/ SW405 Remote
Control.
!
Before assembling your ceiling fan, refer to section on
proper method of wiring your fan (page 12). If you feel
you do not have enough wiring knowledge or experience,
have your fan installed by a licensed electrician.
If your fan is to replace an existing ceiling light fixture, turn
electricity off at the main fuse box at this time and remove
the existing light fixture.
!
To avoid fire or shock, follow all wiring instructions
carefully.
Any electrical work not described in these
instructions should be done or approved by a licensed
electrician.
Please call Emerson
1-800-654-3545 if you have any questions about
installation and operation of this ceiling fan.
4
WARNING
WARNING
technical support
ETL Model No.: CF320
at