Inateck BCST-50 Guia Del Usuario página 4

Normal (default setting)
How to Charge
The scanner enters low-battery mode after long-beeping for 3 times, which means it
requires charging.
The required voltage for charging the scanner is 5V, and current below 500mA.
Current controller chip is set inside the scanner to filter excessive current - for any
current above 500mA, it filters the excessive current and inputs 500mA for charging.
As long as the charging voltage is at 5V, the scanner should function without issue.
You can charge the scanner with a regular phone charger for the voltage output of a
regular phone charger or a laptop USB port is also 5V.
How to Start
You can power on the scanner by pushing the scan button. The indicator will flash
green when the scanner is switched on with a beep.
How to Power Off
Long press the scan button if you want to power off the scanner immediately.
How to Use
Note: When the scanner is connected both via cable and wirelessly, it transmits data
through cable by default
Wired Mode:
1. Connect the barcode scanner with computer via USB cable
2. Open a file on computer and move cursor to the blank where scanning output
should be placed. Scanning results can be displayed on computer then.
Wireless Dongle Mode
The dongle is paired with the scanner automatically when leaves factory.
1. Connect the wireless dongle to the USB port on your laptop, and the laptop will
begin installing the drive for scanner automatically.
2. Press the power button on the scanner, and the scanner is paired successfully with
the dongle with the blue LED lit.
2
Luminous light lit
No luminous light