Advocate KD-7902 Manual De Operaciones

KD-7902
Wrist Blood Pressure Monitor
Wrist Blood Pressure Monitor
Operation Guide
Name of Each Part
Color Coded
Indicator
Pulse
Function Description
Based on oscillometric method and silicon integrate pressure sensor technology, blood pressure and heart rate can be
measured automatically and non-invasively which helps to ease the operation. New blood pressure classification indicator
visually indicates user's blood pressure category, 120 memories with date and time display. These memories are stored in
two groups with a capacity for 60 readings each. The pulse and irregular heart beat (if any) can be indicated.
Specification
1. Model: KD-7902 9. Measuring accuracy: ±3mmHg
2. Machine size:87.2mm×64mm×30.7mm
10. Heart pulse rate range: 40-180 per minute
3. Cuff size: 140mm x 195mm
11. Environmental temperature for using: -5 ~ +40° c
4. Weight: 108g (excluding batteries)
12. Environmental humidity for using: <80%
5. Measuring method: oscillometric
13. Environmental temperature for storage: -20~+55° c
method, automatic air inflation
and measurement
14. Environmental humidity for storage: <95%
6. Memory volume: 2×60 times
15. Environmental pressure: atmosphere pressure
7. Power source: AAA×2 batteries
16. Battery life: Approx.1 month with normal usage
8. Blood pressure measuring range:
0-295mmHg
Measuring Procedures
1. Battery Loading
a. Open battery cover located in the back
left side of the monitor.
b. Load two "AAA" size batteries. Please
pay attention to polarity
c. Close the battery cover.
* When LCD shows battery symbol it
means you must change the batteries at
once. Rechargeable batteries with a voltage
of 1.2V are not suitable for this product.
* Take out all the batteries if the device
will not be used for a long time to avoid
battery leakage and relevant damage.
The equipment, the batteries and cuff used in it can be
disposed as industrial rubbish at the end of their usage, or
according to local regulations.
35104_wrist BPM 7902B manual.indd 1
Systolic
"MEM" Button/Clock Setting
"START" Button/Clock Adjusting
2. Placement of the Wrist Band and Accurate Position for the Measurement
Diastolic
Picture 2-2
2. Placement of the Wrist Band and Accurate Position for the Measurement
a. Be sure to place the wrist cuff on bare skin of left wrist, and place sphygmomanometer on
the center of wrist. (See picture)
b. Place wrist cuff 1~2cm above wrist joint.
c. Close Wrist cuff, make sure your wrist does not feel tension. Don't close it too tight.
(Otherwise the measurement will not be precise).
Prohibition:
This product cannot be used on infants.
This product can not be used on other uses than blood pressure measuring
d. Keep up right position at the same level of your heart. (See figure)
e. To give greater stability to the arm is advisable to put the plastic box that comes with the
meter below the wrist. (See figure)
3. Measuring Process
3. Measuring Process
a. After your body is in a comfortable position, press the "O" button. After a long "beep",
BPM will verify itself, and LCD will display all automatically.
b. Then you will see on screen "U1" or "U2" indicating the Group of memory in which the
2. Clock Mode
2. Clock Mode
a. Once you install the batteries, the LCD will display the time
and date. (See picture1)
3. Clock Adjusting
a. When the machine is in the Clock Mode, press the "
3. Clock Adjusting
and " M " buttons at the same time and release. The machine
a.
enters the Clock Adjusting Mode. The month will twinkle first.
(See picture 2). Press the "M" button continuously to adjust the
number, once you have the correct month number press the
" " button, the day will start twinkling (See picture 2-1) adjust
the day with the "M" button and than press the " " to go to the
time and repeat the same procedure.
b.
c.
b. To exit the Clock Adjusting Mode when you finish, press the " " button and the number will
stop twinkling. (See picture 2-2 & 2-3)
Picture 2-2
a. Be sure to place the wrist cuff on bare skin of left wrist, and place sphygmomanometer on
c. When you change the batteries, you need to readjust the clock.
the center of wrist. (See picture)
b. Place wrist cuff 1~2cm above wrist joint.
c. Close Wrist cuff, make sure your wrist does not feel tension. Don't close it too tight.
3. Placement of the Wrist Band and
Accurate Position for the Measurement
(Otherwise the measurement will not be precise).
a. Be sure to place the wrist cuff on bare skin of left wrist, and place sphygmomanometer on the
Picture 2-3
Prohibition:
center of wrist. (See picture)
This product cannot be used on infants.
b. Place wrist cuff 1~2cm above wrist joint.
This product can not be used on other uses than blood pressure measuring
c. Close Wrist cuff, make sure your wrist does not feel tension. Don't close it too tight. (Otherwise
the measurement will not be precise).
d. Keep up right position at the same level of your heart. (See figure)
d. Keep up right position at the same level of your heart. (See figure)
e. To give greater stability to the arm is advisable to put the plastic box that comes with the
e. To give greater stability to the arm is advisable to put the plastic box that comes with the meter
meter below the wrist. (See figure)
below the wrist. (See figure)
Prohibition:
*
This product cannot be used on infants
* This product cannot be used on other uses than blood pressure measurement
a. After your body is in a comfortable position, press the "O" button. After a long "beep",
BPM will verify itself, and LCD will display all automatically.
b. Then you will see on screen "U1" or "U2" indicating the Group of memory in which the
Once you install the batteries, the LCD will display the time and date.
2. Clock Mode
Once you install the batteries, the LCD will display the time and date.
Once you install the batteries, the LCD will display the time and date. (See picture 1)
3. Clock Adjusting
a. When the machine is in the Clock Mode, press the " O " and " M " buttons at the
and release. The machine enters the Clock Adjusting Mode. The month will tw
(See picture 2). Press the "M" button continuously to adjust the number, once yo
correct month number press the " O " button, the day will start twinkling (See p
Picture 1
adjust the day with the "M" button and than press the " O " to go to the time and
same procedure.
3. Clock Adjusting
Picture 1
"
a. When the machine is in the Clock Mode, press the " O " and " M " buttons at the same time
and release. The machine enters the Clock Adjusting Mode. The month will twinkle first.
(See picture 2). Press the "M" button continuously to adjust the number, once you have the
When the machine is in the Clock Mode, press the " O " and " M " buttons at the same time
correct month number press the " O " button, the day will start twinkling (See picture 2-1)
and release. The machine enters the Clock Adjusting Mode. The month will twinkle first.
adjust the day with the "M" button and than press the " O " to go to the time and repeat the
(See picture 2). Press the "M" button continuously to adjust the number, once you have the
same procedure. correct month number press the " O " button, the day will start twinkling (See picture 2-1)
adjust the day with the "M" button and than press the " O " to go to the time and repeat the
same procedure.
Picture 2
b. To exit the Clock Adjusting Mode when you finish, press the "O" button and
will stop twinkling. (See picture 2-2 & 2-3)
c. When you change the batteries, you need to readjust the clock.
Picture 2
b. To exit the Clock Adjusting Mode when you finish, press the "O" button and the number
Picture 2 Picture 2-1
will stop twinkling. (See picture 2-2 & 2-3)
c. When you change the batteries, you need to readjust the clock.
To exit the Clock Adjusting Mode when you finish, press the "O" button and the number
will stop twinkling. (See picture 2-2 & 2-3)
When you change the batteries, you need to readjust the clock.
Picture 2-3
Picture 2-2
2. Placement of the Wrist Band and Accurate Pos
a. Be sure to place the wrist cuff on bare skin of left
the center of wrist. (See picture)
b. Place wrist cuff 1~2cm above wrist joint.
c. Close Wrist cuff, make sure your wrist does no
(Otherwise the measurement will not be precise).
Prohibition:
This product cannot be used on infants.
This product can not be used on other uses than
d. Keep up right position at the same level of your he
e. To give greater stability to the arm is advisable to
meter below the wrist. (See figure)
See picture 3.
3. Measuring Process
a. After your body is in a comfortable position, p
See picture 3.
BPM will verify itself, and LCD will display al
b. Then you will see on screen "U1" or "U2" indic
8/12/09 11:46:07 AM
(See pictur
(See picture 1)
Picture 1
Picture 2-1
Picture 2-1