Installing The Faucet; Mounting The System Under The Sink - PUR PQC1FS Manual Del Propietário

Installation Instructions (continued):
Installing the Faucet (See Figure 6):
1. Guide Escutcheon Plate (J) and Rubber Gasket (K) onto the stem of Faucet
(I). Slip the stem into the hole and make sure it sits flat on the top of the
sink or countertop surface.
2. From underneath the sink, slide Plastic Lock Washer (L) and Star Washer
(M) up along the stem, then screw Stem Nut (N) all the way up the stem
until it is flush with the Star Washer. Tighten with adjustable wrench
until it is slightly snug and check to make sure the Faucet spout is in the
proper position.
Mounting the System under the Sink (See Figure 7):
1. Choose an easy to access area under the sink to mount the system.
Note: Mount the system to a solid cabinet wall. If a solid wall is not available, use hollow-wall anchor bolts
or toggle bolts (not included) to secure to the wall.
2. Use the Pre-assembled Head Assembly (A) as a template, mark the holes for positioning the system on the wall surface.
3. Insert Mounting Screws (E) into the wall with a Phillips screwdriver, leaving approximately 3/8" of each screw exposed. Hang
the system through the eyes of the bracket on the screws. Tighten the screws to secure the system.
4. Leave 1" clearance below the filters to ensure there is no interference when replacing them.
Figure 7
G
5
Water
Inlet
H
1/4" White
Tubing
Figure 6
J
K
L
M
N
Faucet
1/4" White Tubing
A
Water Outlet
B C
1" Minimum
I
Countertop
O
P
Q
D
E