Tabla de contenido
Idiomas disponibles
Idiomas disponibles
Place This Half
Against A Wall
Figure 11
17. Make sure the legs on the first table top half (the half with the name panel #5) are open and hinges are locked. With one person on each side
of the table, lift and set table half on its legs. Place table against a wall as shown above to help stabilize table top half while second half is being
attached. Be sure there is enough room to connect second half.
CAUTION:
18. Place two hex bolts #9 and locknuts #15 on floor next to caster wheels (on both sides of the table half) so they will be handy for the next step.
CAUTION:
19. With a person on both sides of the second table half, slide the second table half against the first table half. Align holes in name panels #5 (on
first table half) with holes in U-supports (on second table half). Secure second table half to name panel #5 with the two hex bolts #9 and locknuts
#15 you placed on the floor earlier. Tighten locknuts snug but do not overtighten. These joints must pivot. At this point go back and tighten hex
bolts #9.
First Table Half
You Assembled
7
9
BE SURE THE FIRST TABLE HALF YOU ASSEMBLED (WITH NAME PANELS #5
ATTACHED) IS STABLE AND AGAINST A WALL. DO NOT LEAVE TABLE HALF
STANDING UNATTENDED.
UNTIL THE TABLE HALVES ARE CONNECTED THEY WILL NOT STAND ON THEIR
OWN. IT IS RECOMMENDED TO HAVE THREE PEOPLE TO CONNECT TABLE
HALVES. TWO TO STABILIZE TABLE AND ONE TO BOLT TABLE TOGETHER.
5
15
7
6
Second Table Half
You Assembled
Tabla de contenido
