Stiga T8125 Manual Del Usario página 5

11. Gently tap caster sockets #12 into U-support #7 until flange on
sockets touches the edge of the tube. DO NOT HIT CASTER
SOCKET DIRECTLY WITH A HAMMER! SET A PIECE OF
WOOD ON CASTER SOCKET AND HIT PIECE OF WOOD
TO DRIVE CASTER SOCKET INTO U-SUPPORT.
See Figure 9.
12. Insert casters #11 into caster sockets #12. See Figure 9.
AT LEAST TWO ADULTS ARE NEEDED
TO MOVE TABLE HALF!
13. Prepare an area for the assembly of the second table top half. If
necessary, move the first table top half aside with the aid of a
helper. Be sure to place it in a location where it won't be disturbed
or damaged. If setting on its side, be sure to place the bottom edge
no less than 12 inches away from the wall. Also be sure to place
carpet or pieces of the shipping carton down to protect table top
edges. If floor is not carpeted, brace table top half with a heavy
object to keep it from sliding.
14. Repeat steps 1 through 9 on second table half.
15. Gently tap caster sockets #12 into U-support #7 on second table
half until flange on sockets touches the edge of the tube. DO NOT
HIT CASTER SOCKETS TOO HARD WITH A HAMMER. Cast-
ers could break if hit too hard.
16. Insert casters #11 into caster sockets #12 on second table half.
CAUTION:
AT LEAST TWO ADULTS ARE NEEDED TO
COMPLETE THE REMAINDER OF THE
ASSEMBLY!
CAUTION:
Figure 9
7
2
Second
Table Half
5
11
12
7
Figure 10