Samsung WF433B GJ Serie Información Técnica página 3

ALIGNMENT AND ADJUSTMENTS
To avoid risk of electrical shock, personal injury or death; disconnect power to washer
before servicing, unless testing requires power.
Error Code
NO
(Diagnostic Code
Error Image)
9 nF1
10 OE
11 1E
12 E2
13
tE
14
3E
15
2E
16
AE
17
8E
SF1
18
SF2
SF3
19
SUdS
(Techsheet)WF433GJ-03152C-01_EN.indd 3
WARNING
Description
The hot/cold water hose connection is not
correct.
A fault is detected in the water level
sensor.
The Water Level sensor is not working
properly.
A jammed key.
A temperature sensor problem.
A motor problem.
High/Low voltage detected.
A Communication error between the
SUB(Sensor) PBA and the MAIN PBA
A MEMS sensor problem.
A system error
Too many suds are detected during the wash session. The unit is put on hold
until the amount of suds have been reduced. The unit will then go back to
operating. When it finishes washing, the "End" and "SUdS" codes will blink in
turn.
3
Corrective Action
Please connect the hot/cold water
hose connection correctly.
Call customer service.
Call customer service.
Call customer service.
Press the Power button to turn off
your washer, then turn it on again.
If the code reappears, call customer
service.
Restart the cycle. If the code
reappears, call customer service.
Restart the cycle. If the code
reappears, call customer service.
Call customer service.
Call customer service.
Call customer service.
2012-12-04 5:14:15