Charging The Battery - Topcom Protalker 1016 Manual De Usuario

Protalker 1016
8.5

Charging the battery

1. Connect the power jack of the power adapter to the back of the desktop charger.
2. Plug in the power adapter in an easy accessible power socket.
The LED on the front panel of the desktop charger will turn green.
3. Put in the PMR (with installed battery) or the separate battery into the charger.
The LED colour will indicate the charging status of the battery:
• Red : Charging
• Light green : 90% full
• Green : Fully charged
When the battery is fully discharged it will take about 4.5 hours to charge the battery to 90% of
the full capacity. The remaining 10% charging will take about one hour.
So, charging a fully discharged battery to 100% will take about 5.5 hours.
Do not use the PMR while charging the battery. Switch off the power of the
PMR while charging.
Do not short-circuit the batteries or dispose in fire. Remove the batteries
if this device is not going to be used for a long period.
9 The PMR radio
1. Channel selector (16 positions)
2. On-Off/Volume knob
3. Status LED
– Green : Receiving
– Green flashing : Scanning
– Red : Transmitting
T
– Red flashing :Battery low
4. External Speaker/Microphone connectors
5. Speaker
6. Microphone
7. Function key #2 : Monitor key
8. Function key #1 : Scan key
9. PTT-button
10. Fixed antenna
When the status LED is flashing red, battery needs to be recharged.
10
1
2
3
9
4
8
5
7
6
5