BH FITNESS G152X Instrucciones De Montaje página 41

(90) Backrest.
(91) Armrest covering.
(92) Abdominal support.
(93) Long foam covers.
(94) Bottom leg support foam cover.
(136) Seat support adjustment knob.
Fig.4
(95) Front right side panel.
(96) Front left side panel.
(127) Top cover.
(128) Casing bracket.
(129) Ankle strap.
(131) Top leg support foam cover.
(133) Mesh bracket
(134) Mesh
Fig.5 (NUTS & BOLTS)
(97) Slot head bolt M-5x10.
(98) Allen screw M-8x16´.
(99) Bolts M-8x20.
(100) Bolts M-8x58.
(101) Countersunk screw M-10x25.
(102) Bolts M-10x25.
(103) Bolts M-10x35.
(104) Bolts M-10x50.
(105) Bolts M-10x60.
(106) Bolts M-10x65.
(107) Bolts M-10x70.
(108) Bolts M-10x75.
(109) Bolts M-10x80.
(110) Bolts M-10x85.
(111) Bolts M-10x95.
(112) Bolts M-10x100.
(113) Bolts M-10x105.
(114) Bolts M-12x75.
(115) Bolts M-12x135.
Fig.6
(117) Flat washers M-5.
(118) Flat washers M-8.
(119) Flat washers M-10.
(120) Washers M-10.
(121) Flat washers M-12.
(122) Flat washers 40x19,5.
(123) Flat washers 46x26.
(124) Flat washers 32x13.
(125) Self locking M-10.
(126) Self locking M-12.
(130) Washers M-8.
ASSEMBLY.-
1.-Place the main body (5) in the
upright position, as shown in Fig.7.
2.-Place the bases (3-4) onto the main
body (5), as shown in Fig.7, ensuring
the stickers on the left and right match
up, and tighten the screws (111).
3.-Fit the support leg (2) tightening the
bolts (112) against the rear plate Fig.8.
4.-Put the screws (112) into the screw
holes so that they are in their correct
position, without
Make sure the main structure (5)
remains in a vertical position Fig.8.
5.-Fit the top body (1) Fig.9 onto the
main body (5). inserting the tip of the
cable through the hole (M).Hand tighten
the nuts (125) as shown in Fig.9.
NOTE: Once this stage of the assembly
has been completed, all of the bolts
fitted should be retightened securely.
FITTING THE ABDOMINAL
SUPPORT.-
6.-Take the abdominal support (33)
and bolt it onto the main support (5),
using bolts (111) and washers (120) at
the top and the bolts (109) and
washers (120), as shown in Fig.10.
Remove the bolts from the front
support (10), Fig.10. Fit the front
support leg
handtightening all of the bolts (102)
along with their washers (120), Fig.10.
41
tightening Fig.8.
(10) but only