Using The Installation Instructions; Intended Use; Safety - blum BLANCO SELECT AutoMove Manual De Usuario

Using the installation instructions

Please read the installation instructions and safety information before SERVO-DRIVE installation.
We recommend that you use the orientation diagram for easier identification of the parts being described.

Intended use

SERVO-DRIVE supports the opening and closing of lift systems and/or the opening of pull-out elements,
and may only be used under the following conditions:
• In dry, enclosed rooms.
• In combination with a Blum transformer.

Safety

SERVO-DRIVE complies with current safety standards.
Nevertheless, there are certain risk factors if these installation instructions are not followed. Please
be aware that Julius Blum GmbH is not responsible for incidental or consequential damages that may
arise due to non-compliance with these installation instructions.
• All national standards must be followed for SERVO-DRIVE assembly. This includes, in particular,
those related to the mechanical safety of moving parts and electrical cabling.
• Only qualified technicians may install/replace Blum components, modify the position of the Blum
transformer or modify any cabling.
• The device may only be connected to a power supply that corresponds to the type and frequency
listed on the serial tag (see Blum transformer).
• The outlet must be freely accessible.
• Only 1 Blum transformer can be connected to each distribution cable.
• Maintain safety distances to the Blum transformer listed in the installation instructions.
• Make sure that moisture cannot penetrate the Blum transformer and drive unit.
• Before starting repair or maintenance work, unplug the Blum transformer to disconnect the
power.
• The drive unit, Blum transformer and SERVO-DRIVE switch should only be cleaned with a moist
cloth because penetrating moisture and aggressive cleaning materials can damage the electronics.
EN
11