Cleaning Instructions - DeWalt DXSP190652 Manual De Instrucciones

Ocultar thumbs

Contenido

Tabla de contenido

Idiomas disponibles

ASSEMBLY

Pump Handle

Tools Required: 13mm or Adjustable Wrench (not supplied)

1. Slide handle onto shaft and line up holes. Thread bolt

through handle and shaft and securely tighten. Thread on

lock nut and tighten using a 13mm (or adjustable) wrench.

Handle can be mounted on left or right depending on user

preference. (Fig C )

Fig. C

Folding Handle

1. Thread bolt through handle and shaft as stated above. (Fig. D)

Fig. D

2. Snap strap around handle. (Fig. E)

3. Handle shown in folded position. (Fig. F)

Fig. E

OPERATING INSTRUCTIONS

WARNING: RISK OF PERSONAL INJURY DUE TO CHEMICAL

EXPOSURE. Use the appropriate Personal Protective

Equipment (PPE) as recommended by the chemical

manufacturer and/or refer to the chemical Safety Data

Sheet (SDS) of the chemical being used. This includes at

least goggles, gloves, and protective clothing.

Filling

DANGER: RISK OF DEATH, SEVERE PERSONAL INJURY

AND/OR PROPERTY DAMAGE FROM IMPROPER

CHEMICAL USE OR MIXTURE.

• Never use flammable or combustible chemicals in this

sprayer. Spraying flammable or combustible chemicals

can create combustible fumes that could be ignited,

causing an explosion.

• Use only chemicals indicated for spraying applications.

Some chemicals may create a toxic or other hazardous

atmosphere when sprayed.

• Always refer to chemical manufacturer's instructions

and/or the chemical Safety Data Sheet (SDS) for proper

mixture and safe application.

1. Remove the cap from the tank. (Fig. G)

2. Make sure the filter basket is in place in the neck of the tank.

The filter basket includes the seal and must be in place to

prevent leaks.

3. Fill the tank with cool water and chemical to the desired

level.

4. Reinstall the cap.

Fig. G

Pressurizing and Spraying

WARNING: RISK OF PERSONAL INJURY AND/

OR PROPERTY DAMAGE DUE TO UNINTENDED

SPRAYING OF CHEMICAL. Ensure the shutoff is in

the closed position (lever released) before starting to

pressurize the sprayer. The sprayer will spray when

pressurizing, if the shutoff is open (lever depressed).

NOTICE: RISK OF PROPERTY DAMAGE. Only spray when

the air is calm (no wind or air movement) to prevent

chemical spray from drifting onto non-targeted surfaces.

1. To begin pressurizing, be sure shut-off lever is not

depressed. Pump handle up and down in a smooth motion.

(Fig. H.) Operating pressure is reached when pumping

becomes difficult, which is no more than 5-7 full pumps.

(Do not over pressurize)

2. Direct nozzle away from you and squeeze shut-off lever to

Fig. F

begin spraying.

3. To maintain pressure while spraying, operate pump

handle every 8 sec. or as needed.

4. For continuous spraying, squeeze lever and rotate lock.

(Fig. I)

Fig. I

5. Unlock if needed and release shut-off lever to stop spraying.