Operating Instructions; Care And Maintenance - Kobalt SGY-AIR132TZ Manual Del Usuario

OPERATING INSTRUCTIONS

1. Press the trigger (D) to start the
tool (See Figure 1).
NOTE Always be cautious of your hands and
finger placement while tool is running. Always
disconnect air supply when not in use preventing
any accidental firing of the tool.

CARE AND MAINTENANCE

Always remove tool from air supply before performing any maintenance on tool.
An in-line oiler (not included) is recommended to be installed to air supply. It will help
increase tool life and keep the tool properly lubricated. The in-line oiler should be
regularly checked and filled with air tool oil as needed. To check if the in-line oiler is
properly lubricating the tool, place a sheet of paper next to the tool's exhaust ports
while holding the throttle completely open for 30 seconds. The in line oiler is properly
set when a light stain of oil collects on the paper. Excessive amounts of oil should be
avoided.
In the event that it becomes necessary to store the tool for an extended period of time,
the tool should receive a generous amount of lubrication right before being stored.
After being well lubricated, the tool should be run for approximately 30 seconds to
ensure oil has been evenly distributed throughout the tool. The tool should be stored
in a clean and wet dry environment away from the reach of children.
Recommended lubricants: Use air-tool oil or any other high grade turbine oil
containing moisture absorbent, rust inhibitors, metal wetting agent and an EP
(extreme pressure) additive. Consult your local retailer for further assistance in
selecting which air tool oil is best suited for proper lubrication.
STORING
Tool must be well cleaned and lightly lubricated before storing (See Figure 1).
Store air tool in a dry safe place, out of the reach of children.
1
12