Delta 100-DST Guia De Inicio Rapido
Llave de cocina de palanca
Ocultar thumbs
Ver también para 100-DST:
- Manual de instrucciones (12 páginas) ,
- Manual de instrucciones (12 páginas) ,
- Manual de instrucciones (12 páginas)
Enlaces rápidos
Models/Modelos/Modèles
100-DST, 101-DST, 140-DST,
141-DST, 175-DST, 300-DST,
340-DST, 400-DST, 440-DST &
441-DST Series/Series/Seria
Write purchased model number here.
Escriba aquí el número del modelo comprado.
Inscrivez le numéro de modèle ici.
For easy installation of your
Delta faucet you will need:
• To READ ALL the instructions completely
before beginning.
• To READ ALL warnings, care, and
maintenance information.
Para instalación fácil de su llave
Delta usted necesitará:
• LEER TODAS las instrucciones
completamente antes de empezar.
• LEER TODOS los avisos, cuidados,
e información de mantenimiento.
Pour installer votre robinet
Delta facilement, vous devez:
• LIRE TOUTES les instructions avant
de débuter;
• LIRE TOUS les avertissements ainsi que
toutes les instructions de nettoyage et
d'entretien;
SINGLE HANDLE KITCHEN FAUCET
75106
LLAVE DE COCINA DE PALANCA
ROBINET DE CUISINE À UNE MANETTE
You may need/Usted puede necesitar/
Articles dont vous pouvez avoir besoin:
T E FLO N
1
T E FLO N
9/22/15 Rev. B
Manuales relacionados para Delta 100-DST
Resumen de contenidos para Delta 100-DST
- Página 1 You may need/Usted puede necesitar/ Articles dont vous pouvez avoir besoin: T E FLO N For easy installation of your Delta faucet you will need: T E FLO N • To READ ALL the instructions completely before beginning. • To READ ALL warnings, care, and maintenance information.
- Página 2 Si la reparación o su reemplazo no es práctico, Delta Faucet Company tiene DELTA FAUCET COMPANY NO SE HACE RESPONSABLE POR CUALQUIER DAÑO ESPECIAL, la opción de reembolsarle su dinero por la cantidad del precio de compra a cambio de la devolución...
-
Página 3: Mantenimiento
Maintenance Note: Do not attempt to disassemble cartridge (2). There are no repairable parts inside. If faucet exhibits very low flow: A. Remove and clean aerator (1) or B. SHUT OFF WATER SUPPLIES. Replace valve cartridge (2). When reinstalling parts, make sure bonnet nut (3) is tightened securely with a wrench.* Notice If faucet leaks from under handle: Remove handle and unthread trim cap (4). - Página 4 100 & 140 Series / Seria 300 & 340 Series / Seria 300 & 340 Series 100 & 140 Series SHUT OFF WATER SUPPLIES. Remove Insert sprayer and hose (1) down through SHUT OFF WATER SUPPLIES. Remove old faucet. old faucet. Slide gasket (1) over tubes (2) support assembly.
- Página 5 400 & 440 Series / Seria 400 & 440 Series SHUT OFF WATER SUPPLIES. Remove old faucet. Slide gasket Note: If you prefer not to use side sprayer, skip this step (1) over tubes (2) and install onto bottom of faucet. NOTE: If sink is and move to page 8.
- Página 6 101 & 141 Series / Seria 175 & 441 Series / Seria 175 & 441 Series 101 & 141 Series SHUT OFF WATER SUPPLIES. Remove old Note: If you prefer not to use side SHUT OFF WATER SUPPLIES. Remove old faucet.
- Página 7 “SNAP” ‘CHASQUIDO’ «CLAQUEMENT» For Sprayer Models Only Swing open lower clip (1). Pull down on diverter plug (2) to remove. Notice Discard diverter plug. Caution: Do not remove upper clip (3). Keeping lower clip (1) disengaged, insert diverter hose end (4) into diverter Incorrect clip assembly may cause water leaks and property damage.
- Página 8 Faucet fittings (1) are 3/8" compression, with created. Delta is not responsible for tubing that is cut l Tubing is cut too short: buy a coupling union and a ends colored red for hot and blue for cold.
- Página 9 Incorrect Installation Correct method Instalación Incorrecta Método Correcto Installation Incorrecte Bonne méthode Do not install sleeve Ensure cut is straight. upside down. Custom Fit Connections - Plastic Sleeve Installation Instructions No instale la manga Asegúrese que el corte boca abajo. esté...
- Página 10 Setting The Handle Limit Stop (Optional) This faucet includes an integrated handle limit stop that has two positions. Position 1, to the left, allows full handle motion (the full range between “all cold” to “all hot”). The faucet is set in position 1 in the factory. Position 2, to the right, allows half of the normal handle motion (“all cold”...
- Página 11 100-DST, 101-DST, 175-DST, 300-DST & 400-DST Series / Seria 75106 Rev. B...
- Página 12 140-DST, 141-DST, 340-DST, 440-DST & 441-DST Series / Seria All Models / Todos los Modelos / Tous les modèles 75106 Rev. B...