Assembly Instructions - Troy-Bilt TB154 Manual Del Operador

NOTE: Reference to right or left hand side of the cultivator is
observed from the operating position.
Removing Unit From Carton
1. Remove staples, break glue on top flaps, or cut tape at
carton end and peel along top flap to open carton.
2. Remove all loose parts that may be included with unit.
3. Cut along corners, lay carton down flat, remove and set
safely aside any packing material and/or loose cardboard.
4. Roll or slide unit out of carton and check carton thoroughly
for loose parts.
Loose Parts In Carton
• Operator's Manual
Tools Needed for Assembly
• None
ASSEMBLING CULTIVATOR
WARNING:
To prevent serious personal injury,
do not connect electric extension cord to unit until
fully completing cultivator assembly.
Handle Set-Up
1. Loosen each hand knob found on the inside of the upper
handle (Fig. 1).
2. Gently lift and pivot the upper handle into the operating
position (Fig. 2, no. 1).
3. Secure the upper handle and lower handle by tightening
the hand knobs (Fig. 2, no. 2). Each carriage bolt must be
seated properly into the square hole found in the plastic
connector.

ASSEMBLY INSTRUCTIONS

Fig. 1
Fig. 2
5